Xantech SPLCD39G Installation & Programming Manual

15, SmartPad LCD Page: 15 © 2003 Xantech Corporation A B DETAIL A Push Clip with thumb in direction of arrow. Back of clip should move down into SLOT B. If more pressure is needed, use a screw driver as in DETAIL B TAB OF CLIP SCREW DRIVER Detail B STEP 8…

58, Page: 58 SmartPad LCD © 2003 Xantech Corporation 4. Click-and-drag the button to the desired location (must be in GRAPHICS Mode) 5. The button can be re-sized easily by clicking on one of the blue squares outlining the button and dragging the square to the desired siz…

45, SmartPad LCD Page: 45 © 2003 Xantech Corporation NOTE: It is recommended to write down the ASCII command string and a brief description of its corresponding MACRO function. Each ASCII String will need to be entered into the controlling PC device as it appears opposite the …

38, Page: 38 SmartPad LCD © 2003 Xantech Corporation PLACING COMMANDS ONTO THE GTL’s (Creating Macro’s) All of the IR Codes (Palettes or IR Command Groups) should be confirmed and tested before continuing (Same goes for RS232 Commands - ADVANCED only). In the section…

27, SmartPad LCD Page: 27 © 2003 Xantech Corporation INSERTING ADDITIONAL PAGES FOR A SINGLE SOURCE Additional blank pages can be inserted for a given source. After a blank page is inserted, it may be populated with Function Buttons just as in the previous section. This may be usef…

40, Xantech SPLCD39G Page: 40 SmartPad LCD © 2003 Xantech Corporation TRANSFERRING THE PROJECT The project can now be transferred to the SmartPAD LCD™ Touch Screen Panel. NOTE: Before continuing, make sure the PC is connected to the SPLCD display and a ‘BASE UNIT WHO AM I’ can be pe…