Xantrex Truecharge2 Owner's Manual

57, 975-0526-01-02 45 Accessing Charger Information Reverse Polarity Fuse fault • Check for reverse battery polarity (negative connected to negative, positive connected to positive is correct) at battery and charger output terminals. • Disconnect AC and DC sources before replac…

29, Xantrex Truecharge2 975-0526-01-02 17 Installing the Truecharge 2 Battery Charger Step 2: Connecting the DC Chassis Ground (Earth) NOTE: Have an electrician install a properly grounded circuit if one is not available. The Truecharge2 Battery Charger must be connected to a grounded, metal, permanent…

67, 975-0526-01-02 55 Specifications DC Output Specifications Number of isolated battery bank outputs 3 separated outputs DC output voltage range including dead battery charging voltage 12-volt units: 24-volt units: 0 – 16 Vdc 0 – 32 Vdc Maximum equalization voltage 12-volt units: 2…

44, 32 Truecharge2 Series Battery Charger Owner’s Guide Installing Batteries Setting the Battery Temperature without a BTS NOTE: Always be aware of the temperature setting, observe the battery’s actual temperature and adjust the Battery Temperature setting accordingly. For varying c…

32, 20 Truecharge2 Series Battery Charger Owner’s Guide Installing the Truecharge 2 Battery Charger NOTE: If you are using more than one battery, you will need to connect the negative cable from each of the batteries to the negative ground bar or bus. The negative ground bar or bus will then have a…

9, 975-0526-01-02 vii Precautions When Preparing to Charge NOTES: 1. Study and follow all of the battery manufacturer's specific precautions, such as removing or not removing cell caps while charging, whether equalization is acceptable for your battery, and recommended rates of charge. 2. For f…