Ultra Start 42 SERIES Install Manual

1, Covers All 42xx and 43xx Series Remote Starter/Alarms -The system must be placed into Service Mode before any service work is started on the vehicle. It is the sole responsibility of the vehicle owner to ensure that this is done. The manufacturer accepts no liability or responsibility for…

6, Wiring Diagram 14 pin connector BLUE GREEN RED RED YELLOW 1 5 3 2 4 6 Starter Output Heater/Acc Output Power Input Ignition Output Selectable Output Power Input 30amp Output 30amp Output 30amp Input 30amp Input 30amp Output 30amp Output Factory Re-arm Output Starter kill & Anti-Grind Outp…

12, Auto Tach Learn 1) Turn the ignition key to the “ON” position. (The park lights will turn on*). 2) Start the vehicle with the key, The LEDs on the antenna will turn on if a proper tach signal is detected**, then after 30-35 seconds the park lights will flash and the siren will chirp twice t…

16, Ultra Start 42 SERIES Menu 1- User Settings Ignition ON-OFF-ON-OFF-ON Press & Release Program Button Press Button #1 (Lock) Setting 1 Ignition Auto Lock 1) Ignition Lock & Unlock Enable 1 Flash/Chirp Doors Lock/Unlock with Ignition key. 2) Ignition Lock Only 2 Flashes/Chirps Doors Lock when ignition is turned ON …

19, Menu 3- Starter Settings - Continued From Previous Page Setting 2 With 14pin Connector- Gas/Diesel Mode (Auxiliary Connector Pin 12) 1) (-) Input 1 Flash/chirp (-) Glow Plug input. Waits maximum 30 seconds then starts. 2) Time Delay 2 Flashes/chirps Waits for approximately 15 seconds then remote s…

18, Menu 2- Additional Settings...continued from previous page. Menu 3- Starter Settings Ignition ON-OFF-ON-OFF-ON Press & Release Program Button Press Button #3 (Start) Setting 1 Special Door Lock/Unlock Operations (Factory Alarm Rearm). 1) Type 1 1 Flash/chirp Unlock pulse before sta…