Unimac 13 Inch Manual, Important Instructions

1, Page 1 of 5 Important Instructions RSPC ® P.O. Box 990 Ripon, WI 54971-0990 Subject Disassembly of the 13 Inch Roll Heated Flatwork Finisher Use With Models UD13F063 and UD13F078 The roll heated flatwork finisher is delivered as one unit that is approximately 108 inches x 26 inches x 44.5 in…

2, Page 2 of 5 (1-05-3) 2. Remove chain tensioner from right side of machine. Refer to Figure 2. 3. Remove feeding bands. a. With a standard screwdriver, pop clamp open at left end of feeding roller. Refer to Figure 3. b. Remove clamp from roll. c. Peel back adhesive strip from le…

3, Page 3 of 5 (1-05-3) e. Remove screw from left side of top panel (behind feeding roller) Refer to Figure 6. f. Unlock the feeding band roller at the left side interior panel by removing two screws. Keep roller in place and check the direction in which the bearing is mounted. Refer…

4, Unimac 13 Inch Page 4 of 5 (1-05-3) 4. Remove ironing bands. a. Locate the ironing band tension systems on each side of the finisher. Refer to Figure 9. b. Remove tension screw and bracket from press-roller tension spring on each side of finisher. c. Unhook the ironing band tension spring from …

5, Page 5 of 5 (1-05-3) 5. Remove guide ribbons by removing staples. Refer to Figure 11. 6. Remove finger guards. 7. Remove hardware attaching rollers to right side, including screws, sprockets, collars and bearings. Refer to Figure 12. 8. Remove rollers by pulling through to the left…