DFI CL630-CRM Operation & User’s Manual

137, 137 6 Intel AMT Settings 15. In the SOL/IDER/KVM menu, select SOL then press Enter. Select disabled then press Enter. 16. In the SOL/IDER/KVM menu, select IDER then press Enter. Select disa- bled then press Enter. SOL/ IDER/ KVM Username and password <…

35, 35 2 Hardware Installation Rear Panel I/O Ports The rear panel I/O ports consist of the following: • PS/2 keyboard/ mouse port • 1 COM port • HDMI port • DVI-I port (DVI-D signal only) • DVI-I port • 2 Intel LAN port • 6 USB ports • Line-in jack • Line-out jack • Mic-…

80, 80 3 BIOS Setup USB Confi guration Enable or disable XHCI pre-boot driver support. Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc. Version 2.14.1219. Copyright (C) 2011 American Megatrends, Inc. USB Confi guration XHCI Pre-Boot Driver xHCI Mode EHCI1 EHCI2 [Enabled] [Smart Aut…

15, 15 2 Hardware Installation System Board Layout Chapter 2 - Hardware Installation 1 LGA 1155 DDR3_1 DDR3_2 DDR3_3 DDR3_4 Battery Chassis intrusion 1 Fintek F71879F Standby power LED DIO 12 19 1 12 24 ATX power 1 Front panel 2 11 1 SPI Flash BIOS USB 12-13 9 10 1 2 USB 10-11 USB 5-6 10 1 2 1 2 …

120, DFI CL630-CRM 120 4 Supported Software Adobe Acrobat Reader 9.3 To install the reader, click “Adobe Acrobat Reader 9.3” on the main menu. 1. Click Next to install or click Change Destination Folder to select another folder. 2. Click Install to begin instal- lation. 3. Click Finish to exit ins…

127, 127 6 Intel AMT Settings Enable Intel ® AMT in the AMI BIOS 1. Power-on the system then press <Del> to enter the main menu of the AMI BIOS. 2. In the Advanced menu, select AMT Confi guration. 3. In the Advanced menu, select Enable in the AMT fi eld. System ACPI parameters Aptio S…