DFI G4S300-B Operation & User’s Manual

53, 53 2 Hardware Installation 2.6.13 Front Panel Connectors HD-LED: Primary/Secondary IDE LED This LED will light when the hard drive is being accessed. RESET: Reset Switch This switch allows you to reboot without having to power off the system thus prolonging the life of the power supply …

66, 66 3 BIOS Setup 3.1.3 Advanced Chipset Features This section gives you functions to configure the system based on the specific features of the chipset. The chipset manages bus speeds and access to system memory resources. These items should not be altered unless necessary. The default s…

42, 42 2 Hardware Installation 2.6.3 S/PDIF Connector The system board is equipped with a S/PDIF connector. One card- edge bracket, mounted with S/PDIF ports, will be provided as an option. Install the card-edge bracket to the system chassis then connect the audio cable connector to J3. Make…

85, 85 3 BIOS Setup 3.1.6 PnP/PCI Configurations This section describes configuring the PCI bus system. It covers some very technical items and it is strongly recommended that only experienced users should make any changes to the default settings. 3.1.6.1 Reset Configuration Data Enabled The BIOS wil…

43, 43 2 Hardware Installation 2.6.4 Floppy Disk Drive Connector The system board is equipped with a shrouded floppy disk drive connector that supports two standard floppy disk drives. To prevent improper floppy cable installation, the shrouded floppy disk header has a keying mechani…

28, DFI G4S300-B 28 2 Hardware Installation 2.4.2 Jumper Settings for Selecting the CPU’s Front Side Bus 1 3 2 1 3 2 1 3 2 X JP2 JP1JP2 JP1 JP2 JP1 2-3 On1-2 On All Off CPU Auto* 100MHz 133MHz 166MHz 200MHz JP1 1-2 On 2-3 On All Off All Off 2-3 On JP2 1-2 On 2-3 On 2-3 On All Off All Off “*” den…