US Robotics 56 K SOFTMODEM - COMMAND REFERENCE REV 1 Command Reference Manual

13, 56K Softmodem Command Reference - 7 AT Command Set AT commands are issued to the modem to control the modem’s operation and software configuration. The basic command syntax is as follows: • <command><parameter>. The <command> is a combination of the attention …

11, 56K Softmodem Command Reference - 5 Test syntax: +<name>=? The modem responds to this command with a list of the supported parameter ranges. S Register Conventions S registers contain parameters used by the modem. The presentation format for an S register is similar to the format used f…

76, 56K Softmodem Command Reference - 68 OK if <mod> = 3, 24, 48, 72—74, 96—98, 121, 122, 145, 146 and the connection is established. This is a final result code. ERROR if <mod> does not equal 3, 24, 48, 72—74, 96—98, 121, 122, 145, 146 or the connection is n…

16, 56K Softmodem Command Reference - 10 Table 3-4: E<value> Commands F<value>—On-Line Data Character Echo Command This command is supported to ensure compatibility with communications software that issues the F1 command. The F0 version of this command is not supported. T…

103, US Robotics 56 K SOFTMODEM - COMMAND REFERENCE REV 1 56K Softmodem Command Reference - 95 &M Asynchronous communications mode. — &P Pulse dial make-to-break ratio selection. — &Q Asynchronous communications mode. — &S Data set ready (DSR) option. — &T Self-test commands. — &V Display active…