Diamond Systems PR-Z32-E-ST Operation & User’s Manual

14, Prometheus CPU User Manual V1.44 Page 14 4.10 Data Acquisition I/O Connector – J14 (Model PR-Z32-EA only) Prometheus model PR-Z32-EA includes a 50-pin header labeled J14 for all data acquisition I/O. This header is located on the left side of the board. Pin 1 is the lower right pin and is…

46, Prometheus CPU User Manual V1.44 Page 46 Single-ended / Differential Inputs Prometheus can accept both single-ended and differential inputs. A single-ended input uses 2 wires, input and ground. The measured input voltage is the difference between these two wires. A differential input …

17, Prometheus CPU User Manual V1.44 Page 17 The different configurations for J10 are shown below. Each illustration shows only the jumper of interest. An asterisk (*) indicates the default setting. 5.2 J6: Watchdog Timer &…

68, Prometheus CPU User Manual V1.44 Page 68 23.7 Watchdog Timer J9 may be used to connect an external watchdog timer circuit to the CPU. For watchdog timer programming information, see page 20 and the ZFx86 Training Manual included in the Documents folder of the Prometheus CD. 1 Ground…

5, Diamond Systems PR-Z32-E-ST Prometheus CPU User Manual V1.44 Page 5 2. FEATURES System Features Processor Section ♦ 486-DX2 processor running at 100MHz with co-processor ♦ Pentium class platform including burst-mode SDRAM and PCI-based IDE controller and USB ♦ 32MB SDRAM system memory ♦ 50MHz m…

50, Prometheus CPU User Manual V1.44 Page 50 14.7 Convert the numerical data to a meaningful value Once you have the A/D value, you need to convert it to a meaningful value. The first step is to convert it back to the actual measured voltage. Afterwards you may need to convert …