DigiDesign PRE Manual 

39, DigiDesign PRE Chapter 3: Remote Operation 35 Mic Preamp Parameters in the Data Encoder LED Displays The track name is displayed in the Channel Bar display. Channel parameters and values are dis- played in the Data Encoder LED displays, as fol- lows: To change a Mic Preamp parameter: 1 Press …

27, Chapter 3: Remote Operation 23 Declaring Multiple PREs You can configure additional PREs (up to a total of nine) by repeating the above steps. Make sure that none of the PREs are assigned to the same MIDI channel (if daisy-chained) or port (if con- nected to separate ports on your MIDI in…

10, PRE Guide6 Activity LED When lit (green), this LED indicates MIDI data is being received by PRE. Remote “Lock-Out” LED When lit (green), this LED indicates PRE is in Re- mote Lock-Out mode. In this mode, PRE is con- nected to a remote controller (such as Pro Tools or a dedicated de…

7, Chapter 1: Introduction to PRE 3 About www.digidesign.com The Digidesign website (www.digidesign.com) is your best online source for information to help you get the most out of your Pro Tools system. The following are just a few of the services and features available. Product Regis…

48, PRE Guide44 PRE Gain Step Table Table 2. PRE Gain Steps Step vv Level dB 1 00h 0 2 01h 3 3 02h 6 4 03h 9 5 04h 12 6 05h 15 7 06h 18 8 07h 21 9 08h 24 10 09h 27 11 0Ah 30 12 0Bh 33 13 0Ch 36 14 0Dh 39 15 0Eh 42 16 0Fh 45 17 10 48 18 11 51 19 12 54 20 13 57 21 14 60 22 15 63 23 16 66 24 17 69 Ta…

14, PRE Guide10 Channel Mute Switches and LEDs Each PRE channel has a dedicated Mute switch to mute input signal. The respective Mute LED lights when muting is enabled. Channel Select Switches and LEDs These switches are used to “focus” one or more channels to adjust their controls. When lit (gr…