Disc Makers ElitePro Manual, Installation And Setup Gude

16, Disc Makers ElitePro ElitePro Setup Guide 16 Step 9 Load Blank CD’s and Start Duplication You are now ready to begin a job or task on the autoloader. Turn on your unit if you have not already done so. Refer to step seven if necessary. The next steps will take you through a typical setu…

12, ElitePro Setup Guide 12 Step 6 Network Connection You may connect the autoloader to your existing computer network. It may be necessary to change some of the autoloader’s network settings before it will function properly on your network. Connecting the autoloader to y…

4, ElitePro Setup Guide 4 Table of Contents Welcome and Introduction 5 Hardware Overview 6 Unpacking the Hardware (Step 1) 7 Installation of CD Pick Arm (Step 2) 8 Installation and Connection of AC Power Moni…

19, ElitePro Setup Guide 19 STEP 10 DESIGN PRINT IMAGE (LABEL) FOR MEDIA Note: You must be using an Autograph VI CD Printer in the following steps. If you are using another printer refer to documentation that came with your printer. Next you have to prepare a print image that can be use…

21, ElitePro Setup Guide 21 Choose the Text (1) folder at the top. Click on an ABC (2) button and the Centered (3) button. Then click on the New (4) button. Type in the text as shown in the figure below. 1 2 3 4 …

27, ElitePro Setup Guide 27 Using Drive Assigner If Your Unit is trying to use CD/DVD Recorders on your PC, try the following: Due to the fact that DiscJuggler is an open platform that looks at the entire PC system for writers, it can sometimes try to assign your PC’s …