Dot Hill Systems SANnet II 200 FC Installation, Operation & Service Manual

159, Dot Hill Systems SANnet II 200 FC Appendix B Using a Standalone JBOD Array (SANnet II 200 FC Array Only) B-13 B.11.1 Troubleshooting Configuration Issues Follow this sequence of general steps to isolate software and configuration issues. 1. Look for storage-related messages in /var/adm/messages and identify any suspect SANn…

172, F-2 SANnet II 200 FC, SATA, and SATA SE Array Installation, Operation, and Service Manual • March 2005 Note – A DB9-to-DB25 serial cable adapter is included in your package contents for connecting the serial cable to a DB25 serial port on your host if you do not have a DB9 serial port. 2. P…

184, G-6 SANnet II 200 FC, SATA, and SATA SE Array Installation, Operation, and Service Manual • March 2005 1. To list all devices and their paths, start a terminal session and type: Record the device names and paths that you plan to use. 2. Type: A banner is displayed for the spec…

31, Chapter 1 Product and Architecture Overview 1-11 1.2.5 Power and Fan Modules Note – The SATA arrays can only be ordered in an AC configuration. However, DC power supplies can be ordered in an x-option kit, and the SATA arrays can be reconfigured using the DC power supplies. For details, refer to…

105, Chapter 6 Checking LEDs 6-7 The I/O controller module LEDs and their color definitions are shown in Table 6-4. Table 6-4 I/O Controller Module and Battery Module LEDs LED Purpose LED Color Definition Battery Status of battery Solid green – Battery charged Blinking green – Battery charging Sol…

146, A-6 SANnet II 200 FC, SATA, and SATA SE Array Installation, Operation, and Service Manual • March 2005 …