Duerkopp Adler 1183i-7 Instructions For Service Manual

27, 24 4.4 Setting the fork In the starting position of rest of the trimming mechanism, when the holder (1) is in contact with the bracket (2), the axis of the fork (3) must intersect the axis of the shaft (4). Caution! Danger of injury! Switch off the main…

16, 13 3.5.3.1.3 Setting of the lower eccentric The rotation of the eccentric (3) must be delayed in phase by 1/4 revolution against the rotation of the eccentric of the stitch length. This corresponds to the angle of 244° on the handwheel (1), when the setting pin (4) is p…

20, 17 3.6.6 Top roller 3.6.6.1 Selection of the top roller diameter The machine can be supplied with two types of top roller, namely with the diameter of 25 mm and with the diameter of 35 mm. The suitability of the diameter used depends on the type …

32, 29 6.3 Setting the electromagnet current The time response of the current of electromag. has 2 phases: - initial switching on (0,2 ÷ 0,5 s) - the maximum force - maintaining (when keying) It is necessary to set max. 40 % of keying (see instructions for use of the stopmotor). With a higher value t…

28, Duerkopp Adler 1183i-7 25 4.7 Setting the retaining spring of the hook thread The retaining spring (1) holds the hook thread after having performed the trimming. It is to be set in such a way that the force necessary for pulling out the thread from the retaining spring (1) is approximately equal to the force necessary for…

4, 1 1. General safety instructions The non-observance of the following safety instructions can cause bodily injuries or damages to the machine. 1. The machine must only be commissioned in full knowledge of the instruction book and operated by persons with appropriate tra…