Duerkopp Adler 175 Instruction Manual

16, 6 Connecting the sewing drive 6.1 Connecting the sewing drive to the mains ATTENTION ! Work of every kind on the electric equipment of the special sewing machine must only be carried out by electricians or correspondingly trained personnel. The mains plug has to be pulled out! The manufacturer’…

7, Duerkopp Adler 175 1 Scope of delivery The scope of delivery is dependent on your order. Prior to setting up, please check that all required parts are present. This description is valid for a special sewing machine the individual components of which are completely delivered by Dürkopp Adler AG. Equipment: �…

12, 4.2 Mounting the control – Mount the control unit 1 with 4 screws under the table top 8. – Fasten the pow er supply cable of the c ontrol unit with the strain relief clamp under the table top. 4.3 Mounting the set value initiator – Screw angle 7 under the table top 8. – Screw t…

10, 3.4 Setting the working height – The working height can be adjusted between 750 and 900 mm (measured up to the top edge of the table top). – Loosen screws 1 at the spars of the stand. – Adjust the table plate horizontally to the required working height. To prevent tilting, pull the table …

1, 175  176  179 Spezialnähmaschine Betriebsanleitung Instruction manual Postfach 17 03 51, D-33703 Bielefeld • Potsdamer Straße 190, D-33719 Biele feld Telefon +49 (0) 521 / 9 25-00 • Telefax +49 (0) 521 / 9 25 24 35 • www.duerkopp-adler.com D GB Ausgabe / Edition: Ä…

21, 9 Sewing test After finishing the assembly work a sewing test has to be made. – Plug in the mains plug. Caution: Risk of injury ! Switch the main switch off. Thread in needle thread and looper thread only with the sewing machine switched off. – Thread in needle thread and looper thread (see …