Duerkopp Adler 540-100-1 Service Instructions Manual

13, Duerkopp Adler 540-100-1 4.1.4 Submenu for the thread monitor configuration No. Parameter name Symbol Range Description T1.4.1 R epair mode A, B, C Selection of the repair mode to be used. T1.4.2 Needle thread monitor 0 … 10 Number of stitches not registered by the thread breakage monitor before an error …

16, 4.3 Submenu for test functions No. Parameter name Symbol Description T3.1 Multitest Select the submenu Multitest T3.2 Events Select the event display T3.3 DAC III Select the submenu DAC III Parameter T3.4 Data reset Submenu Reset T3.5 Memo dongle Select the submenu Memo dongle 4.3.1…

3, Foreword This instruction manual is intended to help the user to become familiar with the machine and take advantage of its application possibilities in accordance with the recommendations. The instruction manual contains important information on how to operate the machine securely, properly and eco…

7, 1. Elements of the control panel Key Function If no text field is activated: – Change to the parent menu. If a text field is activated: – Change between the figures tenth, unit, ten etc. – Change between the lines in the menus. The selected line is always dark-shadowed. If a text field is ac…

25, 6. Hook and needle bar 6.1 Needle position Standard: The needle (80 Nm) should have a distance of 1.8 mm to the front edge of the knife. Setting: – Loosen screw 3 through drill-hole 4 in the arm. – Shift the needle bar linkage 5 according to the instructions. – Tighten screw 3 again. Attention…