Duerkopp Adler 550-12-23 Operating Instructions Manual

3, Duerkopp Adler 550-12-23 1.3 Noise level Lc Workstation related emmission according to DIN 45635-48-A-1-Kl 2 Number of stitches: 2.140 min-1 stitch length: 5,0 mm alternating sewing feed stroke: 5,6 mm Sewing material: Upholstery vlies with upper cloth 674g/m 2 Lc…

17, 4.4 Setting the Hook-thread Take-up Lever The take-up lever 1 ensures that the thread quantity is automatically matched to the stitch length set. Stitch drawing and stitch formation are therefore always perfect for every stitch length, even with stitch condensation. The drawn-in thr…

19, 4.6 Switching the Edge Cutter On and Off The edge cutter of the 550-12-24 and -26 can be switched in at any time. Its upper knife is so designed as to give a sure cut even when switched in during the seam. Caution Risk of Injury! When switching on the knife do not reach into the c…

5, Element Function 14 - Key block Key F - Switching on tape tension Key Y - Special functions Key P - Programming key/Program number entry Key E - Entry of partial program number Key OH - O-distance with tape Key O - O-distance without tape Keys 1-15 - Calling up crimping values Display - Dis…

12, 3.5 Editing Mode 3.5.1 Altering a Step – If the step to be altered is not shown in the display: - Select the program to be changed. - Select the step which is to be altered. – Hold the "Y" key down and tap the "P" key. The editing mode is switched on. The…

22, 4.9 Threading lower tape feed (550-12-26 only) Caution Risk of Injury ! Before threading turn the main switch off. Threading the tape – Put the roll in place. – Pass tape over clamping lever. – Place top in position. – Thread tape as shown in illustration. – Press key 3 once to …