Dynacord PM 502 Operation & User’s Manual

22, Stereo input GAIN switch Use the GAIN switch for switching between high (HI) or low (LO) input signal amplification. The default setting is LO (-5 dB), which is suitable for all high level input sources like keyboards or CD players. HI gain should be engaged when connecting low signal level …

25, Notice! Effect of MIC PROCESSING The AUX-Bus signal is only affected by MUTE, so COMPRESSOR or TALK OVER have no effect on the AUX-Bus signal. COMPRESSOR Engage the COMPRESSOR switch to activate the integrated compressor. The compressor reduces the dynamic range of audio signals.…

29, Menu item Subitems/parameter range (default setting in bold) Description OUTPUT SETTINGS • DIRECT DRIVE: Off, On/ 50Hz HPF, On/70Hz HPF • AMP ROUTING: MASTER A, MASTER B, AUX, Dual A – B, Dual A – AUX, Dual B – AUX • AUX Mode: AUX-Bus, MAS. A Pre, MAS. A Post Limiters: • M…

38, Circuit diagram METER METER METER LCD 128 x 64 SLIDERS USB-A USB-B LO MID HI LO MID HI DC/DC MIC CHANNELS STEREO CHANNELS STEREO 1 & STEREO 2 VOLUME VOLUME FX FX AUX AUX MIC MIC-FX MIC-AUX ST-L ST-R ST-FX AUX for 5 MIC channels PHANTOM L L R R USB AUDIO INTERFACE USB AUDIO CPU SMPS 5V CD 1/2…

43, Pin assignments UNBALANCED SHIELD HOT Figure 10.1: Unbalanced assignment of mono jack BALANCED SHIELD COLD HOT Figure 10.2: Balanced assignment of stereo jack Figure 10.3: Pin assignment of XLR microphone input with phantom power Figure 10.4: Pin assignment of speaker output CH 1/2 (low-Z…