Sim2 HT200 DMF User And Installation Manual

2, ! CAUTION RISK OF ELECTRIC SHOCK! DO NOT REMOVE THE TOP COVER Prior to switching on the projector please read each chapter of this manual carefully as this manual provides basic instructions for using the projector. The installation of the lamp assembly, preliminary adjustments and procedures that …

9, 9 ENGLISH SWITCH ON FROM STAND-BY By remote control: press one of 1...9 By keyboard: press Up or Down Arrow . Fig. 17 When switching on from stand-by, the projector will turn on the lamp; after a brief warm up period the image will be displayed (green LED on).The input automatically…

13, 13 ENGLISH Not active in this model. MENU - Activates the On Screen Display menus. Navigates menu pages. FREEZE Freezes a moving picture. FOCUS Selects focus lens adjustment. STAND-BY Switches off to stand-by. 0-9 Keys Switch on from stand-by and allow direct source selection. MENU + Activates th…

8, Sim2 HT200 DMF 8 Fig. 14 For rear projection the screen must be translucent. For front projection, we recommend the use of screens with low gain specifications (i.e. 1.3 to 2). The use of high gain screens should be avoided due to their limited viewing angle, which is undesirable for a large audience. Prefer…

15, 15 ENGLISH TINT Controls the purity of the colours, to NTSC coded signal standards. Tint is only applicable to video input with NTSC standard, to RGB 15kHz and YCrCb 15kHz inputs and YCrCb 32kHz (no RI2). SHARPNESS Use this adjustment to increase and decrease the level of picture detai…

5, 5 ENGLISH Fig. 5 The new DMD ™ chip provide two different functioning modes: 4:3 mode (4:3 aspect: 800x600 active pixels) and 16:9 mode (16:9 aspect: 848x480 active pixels). While 4:3 mode matches computer images and traditional vi- deo sources, the 16:9 mode is the ideal soluti…