Edge-Core ES4612 Management Manual

414, Edge-Core ES4612 Command Line Interface 4-100 4 show map access-list ip This command shows the CoS value mapped to an IP ACL for the current interface. (The CoS value determines the output queue for packets matching an ACL rule.) Syntax show map access-list ip [interface] interface • ethernet unit/port - unit …

184, Configuring the Switch 3-136 3 Configuring Protocol Groups Create a protocol group for one or more protocols. Command Attributes • Protocol Group ID – Group identifier of this protocol group. (Range: 1-2147483647) • Frame Type – Frame type used by this protocol. (Options: Etherne…

26, xxvi Figures Figure 3-42 ACL Configuration - Extended IP 3-70 Figure 3-43 ACL Configuration - MAC 3-72 Figure 3-44 ACL Mask Configuration 3-73 Figure 3-45 ACL Mask Configuration - IP 3-75 Figure 3-46 ACL Mask Configuration - MAC 3-76 Figure 3-47 ACL Port Binding 3-78 Figure…

486, Command Line Interface 4-172 4 • Multiple Spanning Tree Protocol - To allow multiple spanning trees to operate over the network, you must configure a related set of bridges with the same MSTP configuration, allowing them to participate in a specific set of spanning tree instances. - A sp…

440, Command Line Interface 4-126 4 Command Usage • You can create a list of up to 16 IP addresses or IP address groups that are allowed access to the switch via SNMP management software. • Address bitmasks are similar to a subnet mask, containing four decimal integers from 0 to 2…

21, xxi Tables Table 1-1 Key Features 1-1 Table 1-2 System Defaults 1-6 Table 3-1 Web Page Configuration Buttons 3-3 Table 3-2 Switch Main Menu 3-4 Table 3-3 Logging Levels 3-29 Table 3-4 SNMPv3 Security Models and Levels 3-35 Table 3-5 HTTPS System Support 3-49 Table 3-6 802.1x Statistics 3-62 …