Watchguard Firebox X1000 Operation & User’s Manual

308, 286 WatchGuard Firebox System described 101 dynamic described 101, 102 service-based dynamic configuring exceptions 107 described 103 disabling 107 enabling 107 using 106 simple dynamic adding entries 104 defining exceptions 105 described 102 enabling 103 reordering entries 105 usin…

116, Chapter 6: Managing and Monitoring the Firebox 94 WatchGuard Firebox System The interfaces used in this section are as follows: eth0 - External (public) interface eth1 - Trusted (internal) interface eth2 - Optional (DMZ) interface ipsec0 - IPSec virtual interface eth0:0 - Interface alias fbd…

74, Chapter 4: Firebox Basics 52 WatchGuard Firebox System 4 If you entered the IP address of a different Firebox, you are asked to confirm your choice. Click Yes. The Firebox Flash Disk dialog box, as shown in the following figure, appears. 5 Select the checkbox marked Save To Firebox. If you wa…

83, Setting DHCP or PPPoE Support on the External Interface User Guide 61 Configuring DHCP or PPPoE support If you enable DHCP or PPPoE on the external interface, you can set several optional properties: 1 From the Network Configuration dialog box, click Properties. The Advanced dialog box appears, …

3, User Guide iii 1. Redistributions of source code must retain the above copyright notice, this list of conditions and the following disclaimer. 2. Redistributions in binary form must reproduce the above copyright notice, this list of conditions and the following disclaimer in th…

10, Watchguard Firebox X1000 x WatchGuard Firebox System ACTIVE, PASSIVE OR IMPUTED) OR FAULT OF WATCHGUARD AND ITS LICENSORS AND ANY OBLIGATION, LIABILITY, RIGHT, CLAIM OR REMEDY FOR LOSS OR DAMAGE TO, OR CAUSED BY OR CONTRIBUTED TO BY, THE SOFTWARE PRODUCT). Limitation of Liability. WATCHGUARD'S LIABILITY (WHETHER I…