Wayne 332200-001 Operating Instructions & Parts Manual

4, 4 www.waynepumps.com 2. With the cover removed, add water to the basin and observe the float control switch operation. 3. Also, test alarm switch if installed. 4. Secure and seal basin cover. Do not run your pump in a dry sump. Do not attempt to oil the motor. A special…

6, 6 For Replacement Parts or Technical Assistance, Call 1-800-237-0987 Please provide following information: Address any correspondence to: - Model number Wayne Water Systems - Serial number (if any) 101 Production Drive - Part description and number as shown in parts list Harrison,…

5, 5 www.waynepumps.com Symptom Possible Cause(s) Corrective Action Pump will not start or run 1. Blown fuse, tripped breaker 2. Low line voltage 3. Defective motor 4. Defective float switch 5. Stuck/ jammed impeller 6. Float obstructed 1. If blown, replace with proper sized fuse or reset break…

1, Wayne 332200-001 Sewer Ejector Pump Description The submersible pump is designed for home applications. The unit is equipped with a 3-prong grounding type power cord. Motor is oil-filled and sealed for cooler running and designed to operate under water. This pump is not suitable for aquatic life, ponds or f…

2, General Information Sewage Pump Systems: Simplex System A simplex system consists of one pump, its control switch, and one basin. It is used in applications where less than six toilets (units) are discharged into a basin. The simplex unit is generally operated with a contactor…