Edirol FA-101 Owner's Manual

4, 4 012b • Immediately turn the power off, remove the AC adaptor from the outlet, and request servicing by your retailer, the nearest Roland Service Center, or an authorized Roland distributor, as listed on the “Information” page when: • The AC adaptor, the power-supp…

2, 2 IMPORTANT: THE WIRES IN THIS MAINS LEAD ARE COLOURED IN ACCORDANCE WITH THE FOLLOWING CODE. BLUE: BROWN: As the colours of the wires in the mains lead of this apparatus may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: T…

12, 12 Front and rear panel fig.rear 17. Power switch Used to switch the power on (DC IN) or off (OFF), and for switching to bus power (BUS). fig.power-sw BUS Bus power can be used if the FA-101 is connected to your computer via a FireWire (IEEE 1394) cable. In this case, powe…

43, 43 Troubleshooting Is the FA-101 connected to a FireWire (IEEE 1394) hub? Try connecting the FA-101 directly to the FireWire (IEEE 1394) connector of your computer itself. Noise may be entering via the line inputs or mic inputs. If a MIDI sound module with a FireWire (IEEE 1394) connect…

16, Edirol FA-101 16 Installing the driver (Macintosh) Now, let’s play back the sample data to verify that the connections and settings are correct. We will use iTunes to play back the sample data provided on the included CD- ROM. Before you continue, connect headphones or monitor speakers to the FA-101 as …

11, 11 Front and rear panel 9. Sample rate select switch This specifies the sampling frequency at which audio data will be recorded and played back. In order to get this setting to take effect, you must exit all of your software, then cycle the power to the FA-101 (switch it off, then back o…