Ei Electronics Ei 204EN Instructions Manual

18, Ei Electronics Ei 204EN 1. Slide off the battery cover as shown in Figure 5a. 2. On the first unit connect twin core cable to the terminals marked 1 and 2 as shown in Figure 8 and bring the cable out through the hole above the terminal block. 3. If they are being surface wired, break one of the three knockout…

3, 1. READ THIS FIRST Power up the unit by smoothly withdrawing the red “pull” tab at the top left hand corner of the unit. If the batteries are supplied separately install the three AA batteries by sliding the upper cover off as shown in figure 5a page 15.The green, red & amber l…

16, Mark the position of the two mounting holes by using the unit as a template. Drill two holes using a 6mm drill for the plastic plugs supplied, (ensure you don’t drill into the house wiring). Screw the unit to the wall. Check that the CO Alarm can be heard in all the bedrooms. If n…

20, (The batteries will usually last over 4 years in standby under normal conditions. An undepleted battery can power a unit in alarm for over 100 hours. The life will be reduced if the unit regularly goes into alarm or if it is exposed to excessive temperatures for long periods). Amb…

1, Model Ei 204EN Model Ei 205EN Model Ei 205ENA Model Ei 205CEN - STANDARD - WITH MEMORY - WITH MEMORY & SEALED IN BATTERIES - WITH MEMORY & INTERCONNECT Read and retain carefully for as long as the product is being used. It contains vital information on the operation and installation.…

31, (2) Ensure there are no fumes in the area (e.g. paint, thinners, hair spray, chemical cleaners aerosol sprays etc). (3) Ensure there is no outdoor source of CO in the vicinity (e.g. a car with engine running, heavy traffic, heavy air pollution, barbecue fumes etc). (4) Press the tes…