Eiki EIP-200 Owner's Manual

55, 51 Removing and Installing the Lamp Unit • Make sure that you remove the lamp unit by the handle. Do not touch the glass surface of the lamp unit or the inside of the projector. • To avoid injury to yourself and damage to the lamp, be sure to carefully follow the steps below. • …

50, Eiki EIP-200 46 Troubleshooting with “Help” menu Utilizing “Help” menu functions This function advises you to solve the problems during usage. • You can adjust the items with check marks (✔). • The items in the “Help” menu change, de- pending on the input signal or setting that you ha…

57, 53 Connecting Pin Assignments COMPUTER-RGB Input/Output COMPUTER-RGB/COMPONENT INPUT1, 2 and COMPUTER-RGB/COMPONENT OUTPUT Terminals: 15-pin Mini D-sub female connector 1. Video input (red) 2. Video input (green/sync on green) 3. Video input (blue) 4. Not connected 5. Not connected 6. Earth (r…

24, 20 Setting up the Projector (Continued) 300 (762 cm) 270 (686 cm) 250 (635 cm) 200 (508 cm) 150 (381 cm) 100 (254 cm) 84 (213 cm) 72 (183 cm) 60 (152 cm) 40 (102 cm) 610 cm (240) 549 cm (216) 508 cm (200) 406 cm (160) 305 cm (120) 203 cm (80) 1…

13, 9 ■ When turning off the projector, the cooling fan runs to decrease the internal temperature for a while. Unplug the power cord after the cool- ing fan stops. The period the cooling fan runs will vary, depending on the circumstances and the internal temperature. Caution regarding us…

12, 8 Observe the following safeguards when setting up your projector. Caution concerning the lamp unit ■ Potential hazard of glass par- ticles if lamp ruptures. In case of lamp rupture, contact your nearest EIKI Authorized Dealer or Service Center for replacement. See “Replacing the Lamp” …