Eiki LC-XB31 Owner's Manual

11, Part Names and Functions 11 Part Names and Functions Remote Control q POWER ON/STAND-BY button Turn the projector on or off. (p.18, 19) w VIDEO button Select VIDEO input source. (p.23, 35) e COMPUTER button Select COMPUTER input source. (p.23, 25, 36) r MENU button Open or close…

62, 62 Appendix Compatible Computer Specifications Basically this projector can accept the signal from all computers with the V, H-Frequency below mentioned and less than 140 MHz of Dot Clock. When selecting these modes, PC adjustment can be limited. MAC LC13 640 x 480 34.97 6…

59, 59 Appendix Menu Tree　 System (1) Mode 1 Mode 2 SVGA 1 - - - - Computer Input ✽ Systems displayed in the System Menu vary depending the input signal. Computer Input/Video Input Sound On/Off Sound 0 - 63 Input Computer 1 ✽ N/A - - - not applicable RGB Go to System (1) N/A Quit …

58, 58 Appendix WARNING: High voltages are used to operate this projector. Do not attempt to open the cabinet. If problems still persist after following all operating instructions, contact the dealer where you purchased the projector or the service center. Giv…

14, To the AC outlet. (200 - 240 V AC) InstallationInstallation 14 This projector uses nominal input voltages of 100-120 V or 200-240 V AC. This projector automatically selects the correct input voltage. It is designed to work with single-phase power systems having a gro…

42, Eiki LC-XB31 42 Setting Blue back Press the Point 7 8 buttons to switch On/Off. When this function is "On", a blue image is displayed while the input signal is not detected. Keystone Press the MENU button to display the On-Screen Menu. Press the Point 7 …