Vertex Standard VX-920 series Operating Manual

7, Vertex Standard VX-920 series VX-920 OPERATING MANUAL 5  Rotate the VOL/PWR knob to set the volume level. If no signal is present, press and hold in the MONITOR button (under the PTT switch) more than 2 seconds; background noise will now be heard, and you may use this to set the VOL/PWR knob for the desired audio level. Pr…

3, VX-920 OPERATING MANUAL 1 WARNING! FCC RF EXPOSURE REQUIREMENTS FCC RF Exposure Compliance Requirements for Occupational Use Only: This Radio has been tested and complies with the Federal Communications Commission (FCC) RF exposure limits for Occupational Use/Controlled exposure environ…

6, VX-920 OPERATING MANUAL 4 OPERATION Preliminary Steps  Install a charged battery pack onto the transceiver, as de- scribed previously.  Screw the supplied antenna onto the Antenna jack. Never attempt to operate this trans- ceiver without an antenna con- nected.  If you have a Spea…

14, VX-920 OPERATING MANUAL 12 CALL/RESET While the DTMF Paging System This feature, if enabled, allows the user to change the 3-digit Page Call code, used to call other simi- larly-equipped stations. Press the assigned program- mable key, followed by the three digits representing the Page Call …

20, Copyright 2005 VERTEX STANDARD CO., LTD. All rights reserved. No portion of this manual may be reproduced without the permission of VERTEX STANDARD CO., LTD. Printed in Japan EC033N150 …