Specifications:205/205204-ltg6234d.pdf file (15 Sep 2023)
|
Whirlpool LTG6234D Washer/Dryer PDF Installation Information (Updated: Friday 15th of September 2023 08:32:43 PM)
Rating: 4.3 (rated by 31 users)
Compatible devices: LTG5243DQ3, LT5000XS, RAM5243A, W10376238C - SP, AWG 327/3 WP, W10150624A, 6 ADP 962, CET8000AQ1.
Recommended Documentation:
® Gas Washer/Dryer PRODUCT MODEL NUMBER OVERALL DIMENSIONS RECESSED AREA AND CLOSET INSTALLATION DRAIN SYSTEM EXHAUST VENTING LTG6234D Gas supply: Dryer is equipped for use with NATURAL gas. Dryer can be converted to L.P. gas. When rigid pipe is used it should be 1/2 inch IPS. When acceptable to the gas supplier and local codes, 3/8-inch approved tubing may be used for lengths under 20 feet. For lengths over 20 feet, larger tubing should be used. This washer/dryer is equipped with its own permanent, flexible gas connector, design-certified by CSA International, for connecting the appliance to the gas supply line. An individual manual shutoff valve must be installed within 6 feet of the dryer in accordance with the National Fuel Gas Code ANSI Z223.1/NFPA 54. Electrical: A 120-volt, 60-Hz., AC-only, 15- or 20-amp, fused electrical supply is required. A time-delay fuse or circuit breaker is recommended. It is also recommended that a separate circuit serving only this appliance be provided. Exhaust venting: Exhaust your dryer to the outside. Four-inch diameter vent is required. Rigid or flexible metal exhaust vent must be used. Do not use plastic or metal foil vent. Exhaust outlet hood must be at least 12 inches from the ground or any object that may be in the path of the exhaust. The dryer can be converted to exhaust out right or left side. Because Whirlpool Corporation policy includes a continuous commitment to improve our products, we reserve the right to change materials and specifications without notice. Dimensions are for planning purposes only. For complete details, see Installation Instructions packed with product. Specifications subject to change without notice. Ref. 8572777 Rev. A 12-12-05 Additional clearances might be required for wall, door and floor moldings. Rear clearance may be 0" when house exhaust system is lined up directly with dryer exhaust. Standpipe drain system - wall or floor The standpipe drain requires a minimum diameter standpipe of 2" (5 cm). The minimum carry-away capacity can be no less than 17 gal. (64 L) per minute. A 2" (5 cm) diameter to 1" (2.5 cm) diameter standpipe adapter kit is available. The top of the standpipe must be at least 39" (99 cm) high and no higher than 96" (2.4 m) from the bottom of the washer. Laundry tub drain system The laundry tub needs a minimum 20 gal. (76 L) capacity. The top of the laundry tub must be at least 34" (86.4 cm) above the floor and no higher than 96" (2.4 m) from the bottom of the washer. Floor drain system The floor drain system requires a siphon break that may be purchased separately. The siphon break must be a minimum of 28" (71 cm) from the bottom of the washer. Additional hoses might be needed. 71 ⁵⁄₈ " (181.9 cm) *32" (81.3 cm) 23 ³⁄₄ " (60.3 cm) 32 ¹⁄₄ " (81.9 cm) 27" (68.6 cm) A. Recessed area B. Side view - closet or confined area C. Closet door with vents 1" (2.5 cm) 1" (2.5cm) 27" (68.6cm) 1" (2.5 cm) 32" (81.3 cm) 5 ¹⁄₂ " (14 cm) 48 in. 2 (310 cm 2 ) 24 in. 2 (155 cm 2 ) 6" (15.2 cm) 3" (7.6 cm) 3" (7.6 cm) AB C Vent Length Chart ° ° xi No. of 90° turns or elbows Type of Vent Box or Louvered hoods Angled hoods 0 Rigid metal Flexible metal 37 ft (11.3 m) 25 ft (7.6 m) 35 ft (10.7 m) 20 ft (6.1 m) 1 Rigid metal Flexible metal 32 ft (9.7 m) 21 ft (6.4 m) 27 ft (8.2 m) 16 ft (4.9 m) 2 Rigid metal Flexible metal 24 ft (7.3 m) 15 ft (4.6 m) 19 ft (5.8 m) 10 ft (3.0 m) NOTE: Side and bottom exhaust adds a 90 turn inside the washer/dryer. To determine maximum exhaust length, add one 90 turn to the chart. 1. Louvered hood style 2. Box hood style 4" (10.2 cm) 4" (10.2 cm) 2 1 4" (10.2 cm) (6.4 cm) Angled hood style * Most installations require a minimum 5¹⁄₂" (14 cm) clearance behind the dryer for the exhaust vent with elbow. A. Louvered hood style B. Box hood style A B Plan installation to use the fewest number of elbows and turns. Maximum length of the exhaust system depends upon the type of vent used, number of elbows and the type of exhaust hood. The maximum length for both rigid and flexible vent is shown in the chart.
AMX Guide Computer Hardware WPD8 (#7CM297)
WPD8, 1, amx/wpd8.pdf
Refrigerator Reference Book #3UTTET
FGHS2655K, 2, frigidaire/fghs2655k.pdf
#5QV837: YS Handbook
YS, 56, york/ys.pdf
Lenze Guide Controller E84AVSC (#MYFWWJ)
E84AVSC, 78, lenze/e84avsc.pdf
Car Speakers User Manual #93T85R
KFC-ST30, 5, kenwood/kfc-st30.pdf
Sharp Guide LCD TV LC-32SB24U (#YV784F)
LC-32SB24U, 10, sharp/lc-32sb24u.pdf
Miele User Manual Ventilation Hood DA 270-4 (#D9VOW5)
DA 270-4, 36, miele/da-270-4.pdf
Konica Minolta Instruction: pagepro 1390MF (#T6S4R2)
pagepro 1390MF, 2, konica-minolta/pagepro-1390mf.pdf
#42V548: LAS350B Handbook
LAS350B, 29, lg/las350b.pdf
#I6QG3A: F25339 User Manual
F25339, 48, rca/f25339.pdf
EN1English,1! This symbol reminds you to read this instruction manual.ContentsInstallation, 2-3Unpacking and levellingConnecting the electricity and water suppliesTechnical dataDescription of the machine, 4-5Touch control panelHow to run a wash cycle or a drying cycle, 6Wash cycles ...
Model & Doc Type: AQUALTIS AQD970D 49 84
Whi rl poqOJLAUNDRY ENGINEERINGMODELSPECIFICATIONSIssue: 1PRODUCT:Kenm0reDryer- 1992Model Sales _ Cart. Wt.No. No. UEst. UAct.96273100 62731 135_37373100 72731 140Width 29"Depth 27 3/4"Top Hgt. 36"Max.Hgt. 43"IEn8. Appr._l_ Date_q_lF_F_n8. Proj.No. L_E506619Sales App_._p_. ...
Model & Doc Type: 96273100 1
ÖKO-LAVAMAT 1271 VI TURBOThe environmentally friendly washer-dryerInstruction bookletAUS ERFAHRUNG GUT95E6050403060504030403040301200900700QUICKEXTRARINSESTARTPAUSEPREWASHWASHRINSERINSE HOLDSPINDRYONOFFCOLDCOTTONSTAIN500DELAYSTARTRINSEHOLDSPINSPEEDPREWASHEASY-CARESDRYINGENDDRYINGTIMEDRYINGPUMP ...
Model & Doc Type: ÖKO-LAVAMAT 1271 VI TURBO 59
1ASKOT7OOT7OOT7OOT7OOT7OO-----SERIES DRYERSSERIES DRYERSSERIES DRYERSSERIES DRYERSSERIES DRYERSSERVICE MANUALSERVICE MANUALSERVICE MANUALSERVICE MANUALSERVICE MANUALCONTENTSCONTENTSCONTENTSCONTENTSCONTENTSIntroduction and Safety RegulationsIntroduction and Safety RegulationsIntroduction and ...
Model & Doc Type: T7OO Series 65
# | Brand | Model | Document Type/File | Pages | File Size | Last Checked |
---|---|---|---|---|---|---|
1 | Whirlpool | WGT3300XQ |
2 | 0.29 Mb | 17/11 | |
2 | Panasonic | NA-V11FX2 |
62 | 24/12 | ||
3 | Indesit | IWB 6123 |
24 | 26/02 | ||
4 | Hotpoint | WDAL 8640 |
16 | 0.75 Mb | 10/11 | |
5 | Asko | D1976 |
32 | 0.38 Mb | 09/12 | |
6 | AEG Electrolux | EWW 167443 W |
28 | 3.14 Mb | 18/01 | |
7 | Hotpoint | WDL520P |
16 | 0.32 Mb | 26/03 | |
8 | Philco | PLD 14961 WD |
164 | 31/03 | ||
9 | Dexter Laundry | WCAD Series |
6 | 01/12 | ||
10 | LG | WM3988HWA |
41 | 03/12 |
# | Brand | Model | Document (PDF) | Pages | Size | Check Date |
---|---|---|---|---|---|---|
1 | Xsens | MTi 600 Series |
22 | 01.04.2024 | ||
2 | Tricity Bendix | SIE 252 |
28 | 0.6 Mb | 18.03.2024 | |
3 | DYNATEK | D2KI |
6 | 0.65 Mb | 02.02.2024 | |
4 | Haier | JW-K42A |
10 | 5.87 Mb | 25.12.2023 | |
5 | M86 Security | 350 |
152 | 14.10.2023 | ||
6 | Craftsman | 917.29604 |
56 | 4.08 Mb | 13.11.2023 | |
7 | Nakamichi | 480 |
32 | 04.01.2024 | ||
8 | Lockly | SECURE |
14 | 24.02.2024 | ||
9 | HIKVISION | DS-2CC192PN-A |
6 | 11.10.2023 | ||
10 | Edwards | AIGX-D-NW25 |
24 | 11.11.2023 |