White-Westinghouse WW-6000 Manual, Instruction Book

27, 13. ACCESSORIES Presser foot for rolled hemming Spool Adapter - #14.. .3 (90) Vinyl cover Waste tray Needle plate for rolled hemming Screw drivers Needles HAx1 SP HAx1 T 705/130 #11.2 (80) Tweezers Net Oiler n Cleaning brush Accessor Lower knife —22 …

28, 14. SPECIFICATIONS Number of threads 4 Threads (3 threads) Number of needles 2 Needles (1 needle) Needles Standard HAx1SP or HAx1T (705/130) #11 (80) Width between two needles 2mm Overedge width Standard 4.5mm (Range 4.2 -.6mm) Size of bight Stitch length 1 —5mm Differential feed ratio 1:0.7—…

23, 7. PIN TUCKING —18— Pin tucking is overlocked so avoid cutting the fabric by raising the upper knife. Pin tucking is suited to the design of a child’s clothing and a lady’s blouse. * Use the presser foot marked “A” and needle plate “A”. (1) Remove the left or right needle to …

24, 8. CORDED OVERLOCK Corded overlock can be used to strengthen stitches when joining elastic materials such as knitted fabrics. There are two ways of corded overlock. (1) Place the slightly wide cord (about 3mm) under the right needle, and sew on. (2) Sew a narrow cord, positioning it …

11, White-Westinghouse WW-6000 I (2) Upper looper threading (B) • Bring the upper looper to its lowest position by turning handwheel toward you. • Draw thread from spool and pass it, through guide ® of the thread stand and then, in order, through guides © (Fig. A). • Thread the hole of upper looper j,using tw…

14, 3-5. Thread Tension Adjustment 7- Set the balance of the tension as weak as possible. Balance of the Loopwer thread: When the lower looper thread is pulled to the top of material, loosen tension dial 3 counter clockwise. (or tighten tension dial 4 clockwise.) When the upper looper th…