WiebeTech RT8 Operation & User’s Manual

3, WiebeTech LLC The RAID type can be changed via a switch on the back of the RAIDTech. The default setting is RAID 1. Note: if you are installing a drive that contains existing data you wish to preserve, check the “Special RAID Instructions” section of this manual before proc…

8, WiebeTech RT8 WiebeTech LLC Technical Specifications Product Name/Code RAIDTech 800 (RT8) Interface 1394b (FireWire 800) using OXUF922 chipset USB 2.0 Interface transfer rates FireWire 800: up to 800Mbps USB 2.0: up to 480Mbps RAID Levels RAID 0, 1 Hardware RAID processor 8032 microproc…

7, WiebeTech LLC RAIDTech User Manual - 7 - Questions & Answers Q1. What happens if power is shut down while the RAIDTech is auto-rebuilding? A: In case of power failure or shutdown during the Auto-Rebuild function in RAID 1 Mode, the controller will remember the re…

4, WiebeTech LLC 5. Plug in the FireWire or USB cable. One end connects to the back of the unit. Insert the other end into the corresponding port on the host computer. Note: The RS232 cable is not required for normal operation. Only connect the RS232 cable when using the RAIDGui…

5, WiebeTech LLC Usage with Macintosh Computers Compatibility The RAIDTech is Plug-and-Play compatible under Mac OS 9.2 and OS X. No additional drivers are needed. The USB2 port is USB 1.1 compatible. The FireWire 800 ports are backwards-compatible with FireWire 400 ports using the i…