Winegard RT8000S Operation & User’s Manual

4, 4 7. Clean roof area where the base feet will be attached to the roof. Do not erase your marks! 8. Put approved sealant in the areas marked for the base feet. Place base feet on top of the sealant and screw down with the (3) #10 screws for each foot. 9. After all base feet are sec…

10, 10 DISH Network satellite 129° coverage area (Dotted area indicates coverage).* DISH Network satellite 61.5° coverage area (Dotted area indicates coverage).* *Coverage maps are for reference only and do not guarantee coverage. *Coverage maps are for reference only and do not guarantee coverage. …

6, 6 Basic RoadTrip Minimax Antenna Wiring TV RECEIVER 120V POWER SAT IN POWER 12VDC RoadTrip Minimax ANTENNA COAX COAX DIRECTV must be set to the “two” satellite, oval dish setting. In some cases, the two satellite option may not be available, when this happens, use the three satellite optio…

5, 5 STEPS 2 & 3 TWO GROUND WIRES 1 FROM VEHICLE 1 BLACK WIRE FROM SATELLITE DISH STEPS 4 & 5 RED POWER WIRE FROM DISH STEPS 6 &7 +12 V FROM VEHICLE ON/OFF ROCKER SWITCH WITH LIGHT (Shown in OFF position.) FIGURE 7 Connecting TWO receivers 1. Connect the …

9, 9 Appendix A Satellite Coverage Maps and Receiver Compatibility A.1 DISH NETWORK PROGRAMMING The RoadTrip Minimax antenna will operate with most DISH Network receivers. Winegard does not recommend using receivers with hard drives not recommended by the manufactuer for mobil…

8, Winegard RT8000S 8 The RoadTrip Minimax antenna does not attempt to nd a satellite or it never moves. The dish never stops on any of the signals that it sees. 1. Check +12 V wires at unit to verify the quick disconnect is locked into the socket. 2. Make sure the RoadTrip Minimax anten…