Empire Comfort Systems VFLL38FP Installation Instructions And Owner's Manual

21, 32707-8-0714 Page 21 Figure 36 2. Apply the accessory decorative media to the shaded area only. See Figure 36. Use enough to cover the oor of the replace, but do not allow the media to reach higher than the ange sur- rounding the burner. Never place decorative media insi…

40, 32707-8-0714Page 40 IP TROUBLESHOOTING 1 If the DFC giving signal lock out: The board should be unlocked to reinitiate a pilot flame ignition (for the correct unlock sequence refer to the DFC Use and Installation Instructions). Is the DFC board in lock out? 1. Verify the electrical co…

11, Empire Comfort Systems VFLL38FP 32707-8-0714 Page 11 3. Lift the complete burner and valve assembly upward, then turn it sideways in replace opening to gain easy access to the junction box. See Figure 13. You may remove the complete burner and valve assembly as shown in Figure 12. Figure 13 4 The junction box is…

10, 32707-8-0714Page 10 JUNCTION BOX WIRING INSTALLATION CAUTION: ALL WIRING SHOULD BE DONE BY A QUALIFIED ELECTRICIAN AND SHALL BE IN COMPLIANCE WITH ALL LOCAL, CITY AND STATE BUILDING CODES. BEFORE MAK- ING THE ELECTRICAL CONNECTION, MAKE SURE THAT MAIN POWER SUPPLY IS DISCONNECT…

36, 32707-8-0714Page 36 PROFLAME - IP CONTROL SYSTEM KEY LOCK This function will lock the keys to avoid unsupervised operation. To activate this function, press the MODE and the UP Arrow Key at the same time (Figure 63). To de-activate this function, press the MODE and the UP Arrow Key at the same tim…