Emulex LP9002C Installation And Reference Manual

5, Install the Host Bus Adapter Board Record IEEE and serial numbers. Each host bus adapter port is shipped with a unique address identifier called the IEEE address. Since this adapter has two ports, there are two IEEE addresses. The IEEE address is used when configuring your system. The …

9, ON Fast Blink (4 Hz) Normal − 2 Gb Link Rate Slow Blink (1 Hz) OFF Normal − Link Down or Not Yet Started Slow Blink (1 Hz) On Not defined Slow Blink (1 Hz) Slow Blink Off−line for Download Slow Blink (1 Hz) Fast Blink Restricted Off−line Mode (Waiting for Restart) Slow Blink (1 Hz)…

21, Emulex LP9002C maintenance, service operations or adjustments can be performed the GBIC. Small Form Factor Transceiver The small form factor transceiver is an integrated duplex data link for bi−directional communications over multimode or single mode optical fiber. Each small form factor transceiver consists…

18, Laser Safety Notice This laser safety information contains certification and product information covering laser products known as optical Gigabaud Link Modules (GLMs), Gigabit Interface Converters (GBICs), 1x9 and small form factor transceivers sold as accessories to or incorporated…

8, Apply Power Verify the host bus adapter is securely installed in the computer.1. Verify correct media is attached.2. Turn on computer.3. Observe the Power LED.4. Observe status LEDs for Power On Self Test (POST) results.5. View LEDs The power LED and the two status LEDs are located on th…

13, FCC Compliance Information Statement; Models LP9000−N1/L1/T1 (GBIC Models): This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, inc…