EnGenius ENH202 Operation & User’s Manual

65, 10 Network Configuration Example This chapter describes the role of the ENH202 with 4+1 modes. The Access Point mode’s default configuration is a central unit of the wireless network or as a root device of the wired environment. Repeater mode and Mesh network mode need fut…

57, enter following http://<IP address>:8080 to access the web interface. Save/Apply / Cancel Press Save/Apply to apply the changes or Cancel to return previous settings. Press Save/Apply will change the setting immediately. It will not be able to undo the action. …

42, EnGenius ENH202 7 LAN Setup This section will guide you to setup the Local Area Network (LAN) settings 7.1 IP Settings This section is only available for Non-Router Mode. IP Settings allows you to LAN port IP address of the ENH202. IP Network Setting Select Radio button for Obtain an IP addre…

48, 8.1.3 PPPoE (Point-to-Point Protocol over Ethernet) Select PPPoE as your WAN connection type if your ISP provides Username and Password. PPPoE is a DSL service and please remove your PPPoE software from your computer, the software is not worked in ENH202. Internet Connection Type …

32, 6.2.2 WPA-PSK Security Mode Select WPA-PSK from the drop down list to begin the configuration. Encryption Select Both, TKIP or AES for Encryption type. Passphrase Specify the security password. Group Key Update Interval Specify Group Key Update Interval time. 802.11n does n…

18, 4.5 Connection Status Click on the Connection Status link under the Status drop-down menu. This page displays the current status of the network, including network type, SSID, BSSID, connection status, wireless mode, current channel, security, data rate, noise level and signal …