EnGenius EP802 Operation & User’s Manual

23, ~45~ Programmable Feature Call 1. If EP802 base station is installed behind a PBX system, it is feasible to pre-program some feature call along with the PBX’s feature code into the system. 2. Up to 10 most frequently used feature call codes can be pre- programmed. …

22, ~43~ 2. Press MENU-4-3 to enter Call Barring. Enter the password of handset, followed by OK (Left) soft key Block Outgoing Call 1. Press SELECT left soft key to select to block “Outgoing” and confirm your selection. 2. Use or scrolling key to …

12, ~23~ Charger Illustration Handset charging slot DC in ~24~ Charger Features 1. DC In Connects to Charger AC Adaptor. 2. Handset Charging Slot a. Charge handset battery when handset is placed in cradle. b. Refer to the handset LCD for c…

7, EnGenius EP802 ~13~ Handset Features Basic Handset Features 1. 4-line LCD (Liquid Crystal Display) a. The LCD display has LED (Light Emitting Diode) for backlighting. b. The 1 st line of LCD consists of icons. c. Icons explanation from left to right (1) RSSI level (Receive Signal…

14, ~27~ Basic Operations Operation Modes Both the base station and handset have levels of operation at which time only certain procedures of functions can be performed. A. Base Operation Modes 1. STANDBY mode- this is the default mode. The page key is active in standby mode only. T…

18, ~35~ then, within 2 seconds, press the digit “＊” to unlock. 3. Once returning back to standby mode for 15 seconds, the keyguard will be automatically enabled. 4. Key Guard is in effect until unlocked. Battery Recharge and Replacement 1. Charge the b…