Takagi T-M32 Installation Manual And Owner's Manual

43, - 43 - Dual-purpose hot water heating (Domestic and Space Heating): Priority Control Devices such as a flow switch, an Aquastat or other electronic controller can be used to prioritize the domestic water system over the heating system. W…

5, -5 - INSTALLATION All gas water heaters require careful and correct installation to ensure safe and efficient operation. This manual must be followed exactly. Read the “Safety Guidelines” section at the beginning of this manual. • The warranty will not cover damage …

16, - 16 - Size the gas pipe appropriately to supply the necessary volume of gas required for the T-M32 (240,000 BTU/H for Natural Gas or 240,000 BTU/H for Liquid Propane) using ANSI233.1/NAPA 54 in the USA or CAN/CSA B149.1 in Canada or local codes. Otherwise, flow capabilities an…

32, Takagi T-M32 - 32 - *To change the TM-RE30’s mode from Default Mode to High Temperature Mode, please follow the procedures below (the TM-RE30 must be installed prior to operating these procedures): DO NOT set to 185ºF if you use your T-M32 in a recirculation system. This will cause damage…

34, - 34 - The dark squares indicate the direction the dipswitches should be set to. TEMPERATURE SETTINGS • There are 8 preset temperatures that you can select from by changing the dipswitch settings on the computer board. • The temperature has been preset at the factory to 120ºF (49ºC)…

40, - 40 - OPERATING SAFETY FOR YOUR SAFETY READ BEFORE OPERATING WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life. A. This water heater does not have a pilot. It is equipped with an ignition devi…