Talkswitch 48-CA Operation & User’s Manual

145, Specifications 139 Extension Interface C.O. Interface Loop range 0 to 600 ohms On hook voltage 35 volts Off hook loop voltage source 35 volts Off hook loop current 27 to 40 mA Ringing voltage 90 volts RMS Ringing frequency 20 Hz - True Sine wave Total supported ringing load 5 REN Trunk type Lo…

17, Installing TalkSwitch 11 2.4 Plugging into the Back Panel 2.4.1 Attaching telephone lines to TalkSwitch line jacks You can connect your telephone lines from the wall jack(s) to the TalkSwitch line jacks with the phone cables provided. Take note of which telephone line is connected to w…

12, Talkswitch 48-CA 6 TalkSwitch User Guide What is a port number? In an IP address like 64.26.209.103:5060, the port number is the number after the colon ‘:’. For this example, 5060 is the specified port. Port numbers are required so that a computer or device can support multiple applications o…

22, 16 TalkSwitch User Guide 2.5.3 Changing the Unit ID If you need to change the Unit ID of any TalkSwitch system, you can first press from a Local Extension to enter command mode, enter a password if necessary, then dial 0 0 . The system will respond with the Unit ID of that pa…

13, Installing TalkSwitch 7 2.1 What’s included with TalkSwitch The TalkSwitch 48-CA/CVA comes shipped with the following items: 1. The TalkSwitch Unit 2. AC Power Adapter (Warning: never use any power adapter other than the one provided.) 3. 6' RJ-45 Ethernet Cable 4. 6&apo…

113, Using TalkSwitch 107 2. When the Auto Attendant answers a call and transfers the caller to an extension, the caller will not hear any pre-recorded message. They will hear your extension ringing and your music. If you DO NOT ENABLE Music-on-Hold and do not have an audio device plugged into…