Sagem MF9500 Operation Manual

6, 5 Touch Panel (basic screen of copy mode) When the copy mode key is pressed, this display screen will appear showing the basic copy mode selections. (For the display screens for other modes, see the respective operation manuals for those modes.) Message display Basic status messages are displayed…

35, Sagem MF9500 34 Device control Original size detection and disabling of the document feeder can be set. Original size detector setting This program is used to select the group of original sizes to be detected. Original size detection from the document glass can be disabled using the program CANCEL DETECTION …

24, 23 Pamphlet copy The pamphlet copy function is used to arrange copies in proper order for eventual center-stapling and folding into a booklet. Two original pages are copied onto each side of copy paper. Four pages are, therefore, copied onto one sheet. [Example] Copying eight orig…

8, 7 SETTING ORIGINALS ■■ ■■ ■ When using the document glass Open the document cover, place an original face down on the document glass, and then gently close the document cover. Original size detector NOTE Do not place any objects under the original size detector, because th…

2, 1 INTRODUCTION This manual describes only copier features. For operation procedures relating to both the basic printer and copier features, refer to the “Operation manual (for printer operation and general information)”. General information required for loading paper, adding toner, misfeed remov…

22, 21 Erase The erase function is used to erase the shadow lines on copies produced when copying thick originals or books. The erase modes that can be selected are shown below. The erase width is approximately 1/2" (10 mm) in it’s initial setting. Edge erase Eliminates shadow li…