Epic EPTL818040 Operation & User’s Manual

22, Epic EPTL818040 22 HOW TO CONNECT YOUR VCR Note: If your VCR has an unused AUDIO OUT jack, see instruction A below. If the AUDIO OUT jack is being used, see instruction B. If you have a TV with a built-in VCR, see instruction B. If your VCR is connected to your home stereo, see HOW TO CONNECT YO…

27, 27 HOW TO LOWER THE TREADMILL FOR USE 1. Hold the upper end of the treadmill with your right hand as shown. Using your left hand, pull the latch knob to the left and hold it. Pivot the treadmill down until the frame is past the latch pin. Slowly release the latch knob. 2. Hold the…

11, 1 1 HOW TO TURN ON THE POWER Plug in the power cord (see page 9). Locate the reset/off circuit breaker near the power cord. Make sure that the breaker is in the reset position. Stand on the foot rails of the treadmill. Find the clip attached to the key (see the drawing on page 10), and…

17, 17 HOW TO USE A CUSTOM PROGRAM Insert the key into the console. See HOW TO TURN ON THE POWER on page 11. Select one of the custom programs. To select a custom pro- gram, press the Program Select button repeatedly until one of the two Custom Program indicators lights. When a custom pr…

8, 95 86 86 88 99 90 5. See step 1. Hold the Right Upright (95) while another per- son holds the Left Upright (90). Remove the two Upright Bolts (86) used in step 1. Slide the Right Upright (95) and the Left Upright (90) fully onto the brackets on the Base (99) at the same time. Be ca…

16, HOW TO CREATE A CUSTOM PROGRAM Insert the key into the console. See HOW TO TURN ON THE POWER on page 11. Select one of the custom programs. To select a custom pro- gram, press the Program Select button repeatedly until one of the two Custom Program indicators lights. Note: If the custom program h…