Salus 091FL RF Operation & User’s Manual

9, 7 GB TESTING THE RF TRANSMISSION It is important to site the Receiver and Control Centre in locations where the RF signal cannot be interrupted. The receiving range between Control Centre and Receiver is 60M in open area. Many factors can affect the RF transmission, shorten…

10, 8 GB INSTALLAING THE CONTROL CENTRE Select a suitable location for the control centre. The location of the control centre can greatly affect its performance. If it is located where air circulation cannot reach, or exposed to direct sun light, it will not adjust the room temperature properly…

7, 5 GB RF Address Code Setting If there is another user nearby, e.g. in the next house, your receiver may be fault triggered by their transmitter. You may select a different RF address code to prevent this. The receiver can only respond to RF transmissions with the same addre…

18, Salus 091FL RF 16 GB Time hold Timer hold is an alternative to manual override. Press and hold ☼ (or  ) key for few seconds, the hold time will appear. Press the key again to set the hold time. Press OK to return to normal operation mode. The maximum can be set is 24 hours. In the hold p…

14, 12 GB 2, Set day/time To set day, press d. Similarly, press h to set hour and m to set minute. Buttons used: Example: When start or after reset, the time is 00:00, Sunday. To set the clock to current time (e.g., 11:23, Tuesday), press d for day, h for hour …