Tannoy TX2 Operation & User’s Manual

7, 6 TECHNICAL SPECIFICATIONS Inputs Two electronically balanced inputs on 3 pin XLR connectors. Input impedance 10 kΩ. Outputs Three electronically balanced outputs on 3 pin XLR connectors. (Left, Right and Mono Sub) Output impedance 50 Ω. Max. level +20 dBV. Hum and Noise -90 dBV, …

6, 5 SERVICING If servicing is required, it must only be carried out by qualified personnel. Do not remove the top cover as there may be a risk of electric shock. Fuse replacement. Disconnect the TX2 from the mains power supply, and pull back the fuse drawer located at the bottom of the mai…

3, 2 INTRODUCTION Thank you for purchasing the Tannoy TX2 loudspeaker system controller. The TX2 is an advanced electronic controller intended to optimise the performance of Tannoy loudspeaker systems. It can be used in full range mode where it performs equalisation functions, extending the l…

9, Tannoy Loudspeakers are manufactured in Great Britain by : Tannoy Limited, Coatbridge, ML5 4TF. SCOTLAND Telephone: +44 (0)1236 420199 Fax: +44 (0)1236 428230 Internet:http://www.tannoy.com TGI/Tannoy, 300 Gage Avenue, Kitchener, Ontario, CANADA, N2M 2C8 Telephone: (519) 745 1158 Fax: (519) 745…

4, 3 Input connections. As with other devices of its type, the TX2 controller is inserted in the audio chain between the last link of audio source (mixing console, preamp, CD player, etc.) and the power amplifiers. The two audio inputs are the 3 pin female XLR connectors on the rear panel, marked L fo…