TDK-Lambda Z160-1.3 Operation & User’s Manual

22, 21 Z + 200 Series Specifications INPUT CHARACTERISTICS Z 160-1.3 320-0.65 650-0.32 1. Input voltage/freq. (*3) --- 85~265Vac continuous, 47~63Hz, single phase 2. Maximum Input current 100/200VAC (*4) (*15) --- 2.64/1.30 2.64/1.30 2.64/1.30 3. Power Factor (Typ) --- >0.99 at …

62, TDK-Lambda Z160-1.3 67 5.5 Parallel Operation 5.5.1 Introduction Up to six units of the same Voltage and Current rating can be connected in parallel to provide up to six times the output current capability. One of the units operates as a master and the remaining units are slaves. The slave units are …

14, 13 PARTS SUBSTITUTIONS & MODIFICATIONS Parts substitutions and modifications are by authorized TDK-Lambda service personnel only. For repairs or modifications, the instrument must be returned to TDK-Lambda service facility. AUSWECHSELN UND VERÄNDERUNG VON BAUTEILEN Das Auswechs…

42, 47 3.9.11 Grounding Outputs Either the positive or negative output terminals can be grounded. To avoid noise problems caused by common-mode current flowing from the load to ground, it is recommended to ground the output terminal as close as possible to the power supply chassis ground. Al…

102, 107 CURRent:MODE This command selects FIX, LIST, WAVE subsystems control over the power supply output current. SCPI Command Syntax [SOURce]:CURRent:MODE <CRD> GEN Command Syntax None Parameters NONE | FIXed | LIST | WAVE *RST Value NONE Examples CURR:MODE LIST CURR:MODE FIX Query Syn…

17, 16 1.2.4 Multiple Output Power System The Z + Series power supplies series can be configured into a programmable power system of up to 31 units using the built-in USB or RS232/RS485 communication port in the power supply and the RS485 linking cable provided with each power supply. In …