ESAB MultiPower 460 Pulse Instruction Manual

13, 13 Figure 2-3. Pulse Control Panel SECTION 2 DESCRIPTION C. CONTROL PANEL DESCRIPTION (Refer to Figures 2-3 and 2-4) 1. FAULT LAMP The RED fault light on the MultiPower 460 Pulse front panel indicates a problem with set-up parameters. A "Steady" light "On" indicates…

32, 32 SECTION 4 OPERATION Step 6. Set the shielding gas flow rate to 35 cfh by activating the gas purge switch on the wire feeder or pulling the gun trigger and turning the adjustment knob on the Flowmeter Step 7 Set the voltage knob on the wire feeder to the "5" or center 12 o'cloc…

33, 33 SECTION 4 OPERATION 4. SHIELDING GASES Table 4-2 lists the types of shielding gas mixtures that can be used with the MultiPower 460 Pulse. The wire burn-off rate and synergic operation can vary with changes in shielding gas. The TRIM knob is used to compensate for small changes …

36, 36 g CONDITION ACTION Unit Inoperative A. B. C. D. E. No input power. Check main line (user's) switch fuses -- replace if needed. Poor or improper input (terminal board) connections. Defective on/off switch -- replace. Thermal light on. Main transformer overheating. Also check …

15, 15 Figure 2-5. MultiPower 460 Pulse 7. INDUCTANCE TRIM This control is used only in the STANDARD mode and is deactivated in the TIG, STICK and PULSE modes. Inductance is used to optimize short circuiting arc performance by changing the current rise and fall time of each short circuit. This resul…