Euphonix Two HDCD Operation & User’s Manual

37, ® INC. PACIFIC MICROSONICS 37 Setup & Operation Model Two HDCD ® User’s Manual Rev. C - January 2002 HDCD 16-bit Dithers From the Operating Menu select (SETUP/OUTPUT/OUT_1 or OUT_2/DITHER or MORE...). HDCD 16-bit dither options allow optimizing perceived timbral and spacial accura…

42, ® INC. PACIFIC MICROSONICS 42 Reference Model Two HDCD ® User’s Manual Rev. C - January 2002 Function Buttons 1 - 4 select HDCD 16-bit encode and monitor modes. Button #1 (PEAKEXT) selects if Peak Extension or HDCD Limiting are on or off, button #2 (LOWLVL) selects if normal Low Level Ext…

38, Euphonix Two HDCD ® INC. PACIFIC MICROSONICS 38 Setup & Operation Model Two HDCD ® User’s Manual Rev. C - January 2002 that will almost always be in the limiting curve, unless a highly limited or distorted sound is desired during undecoded playback. Typically, Peak Extension recordings do not have the…

10, ® INC. PACIFIC MICROSONICS 10 Installation Model Two HDCD ® User’s Manual Rev. C - January 2002 Processor rear panel I/O connections and Analog Input Attenuator. 1 DC Power Input Connects to the DC Output on the Power Supply using (28-pin male) the supplied DC power cable. 2 Analog Input…

61, ® INC. PACIFIC MICROSONICS 61 Reference Model Two HDCD ® User’s Manual Rev. C - January 2002 Function button #1 (1XOP) toggles between three levels of DAC dither for 44.1 kHz (1_X) signals. Button #3 toggles between four levels of DAC dither for 88.2/176.4 kHz (2_X/4_X) signals. Once…

53, ® INC. PACIFIC MICROSONICS 53 Reference Model Two HDCD ® User’s Manual Rev. C - January 2002 The A/D REF clock mode is displayed on the top right of the menu and is set using the Reference Clock Menu, selected by function button #1 (REFCLK). Button #2 (HDCDBIT) selects the Moni…