EUTECH INSTRUMENTS ALPHA CON 200 CONDUCTIVITY CONTROLLERTRANSMITTER Instruction Manual

28, 24 9 RELAYS The alpha CON 200 features two SPDT non-powered relays; rated for 6A at 110 VAC, 250 VAC maximum. When your process exceeds the set parameters of a relay set point, the REL 1 or REL 2 indicator lights up. To set parameters for relay one and relay two, see Setup p…

32, EUTECH INSTRUMENTS ALPHA CON 200 CONDUCTIVITY CONTROLLERTRANSMITTER 28 Appendix 3: External Relays The relays on the alpha CON 200 series controller are rated for 6 amps at 110 VAC and can be wired directly to your final control element (provided its power requirements does not exceed this). However, to preserve the life of your controller, or if high…

4, TABLE OF CONTENTS 1 INTRODUCTION 1 2 SAFETY INFORMATION 2 3 OVERVIEW 3 3.1 F RONT P ANEL 3 3.2 B ACK P ANEL 4 3.3 W IRING 5 3.4 P ANEL - MOUNTING THE CONTROLLER 6 4 MEASUREMENT MODE 7 5 PASSWORD 8 6 CONDUCTIVITY CALIBRATION 10 7 …

16, 12 7 TEMPERATURE CALIBRATION IMPORTANT: When Calibration mode is entered, controller automatically goes into a “HOLD” mode where the 4-20 mA output freezes and relays are de-activated (if it was in an activated condition). Upon return to measurement mode, both 4-20mA ou…

29, 25 11 SPECIFICATIONS Conductivity Range Resolution Cell Constant 0.00 – 20.00 µS/cm 0.01 µS/cm 0.1 0.0 – 200.0 µS/cm 0.1 µS/cm 0.1 0.0 – 200.0 µS/cm 0.1 µS/cm 1 0 – 2000 µS/cm 1 µS/cm 1 0.00 – 10.00 mS/cm 0.01 mS/cm 1 0.00 – 20.00 mS/cm …