Exmark Lazer ZXS Operator's Manual

25, - 20 - 3/16” TO 1/4”(.47-.64 cm) Drive Linkage Neutral Lock / Park Brake Latch FIGURE 7 PISTOL GRIP HANDLES NEUTRAL LOCK LEVER CLEARANCE NOTE: Neutral lock/park brake latch clearance should be checked when there is a slight up…

32, Exmark Lazer ZXS - 27 - c) Belt must be tight enough to not slip during heavy loads while cutting grass. Overtensioning will reduce belt and spindle bearing life. To adjust belt tension, loosen the 5/16" whizlock nut on turnbuckle and rotate the turnbuckle; rotate turnbuckle toward rear…

38, - 33 - 9. 2-Year Limited Warranty Exmark Turf Equipment (For units purchased on or after October 1, 2004) Conditions and Products Covered Exmark Mfg. Co. Inc. and its affiliate, Exmark Warranty Company, pursuant to an agreem…

28, - 23 - LUBRICATION CHART FITTING LOCATIONS INITIAL PUMPS FITTING QUANTITY 32" 3 6" 4 8" SERVICE INTERVAL 1. Caster Wheel Bearings 12 2 2 2 Daily 2. Caster Pivots 2 2 2 2 Daily 3. Drive Wheels 18 2 2 2 Daily 4. Driv…

30, - 25 - d) Loosen but do not remove the two (2) axle pivot bolts and the two (2) axle adjustment bolts (See Figure 11). e) Place a jack under the rear center of the engine deck. f) Raise the back end of the engine deck up enough to remove the two (2) axle …

22, - 17 - 4. MAINTENANCE AND ADJUSTMENTS 4.1 PERIODIC MAINTENANCE WARNING POTENTIAL HAZARD ♦ While maintenance or adjustments are being made, someone could start the engine. WHAT CAN HAPPEN ♦ Accidental starting of the engine could seriously injure you or ot…