Manual, Installation Instructions for TJERNLUND 950-0750 SS1C FAN PROVER KIT 8504037 REV. 0994 Other (1 pages)
Data: UPD 10th October 2023
TJERNLUND 950-0750 SS1C FAN PROVER KIT 8504037 REV. 0994 Other PDF Installation Instructions (Updated: Tuesday 10th of October 2023 10:35:36 AM)
Rating: 4.4 (rated by 68 users)
Compatible devices: 950-0017 SS2 IMPELLER KIT 8504070 REV. 0398, V1, V1D, V2D CRAWL SPACE VENTILATORS 8504129, 950-2061 PILOT SAVER KIT 8504028 REV 2 0995, 950-0625 SS1 MOTOR KIT 8504016 REV. A 1199, PS1505 FAN PROVER 8504008 REV 1 0197, DUCT BOOSTER IN-LINE DUCT FANS 8500380 REV. A 0104, EA5 DUCT BOOSTER FAN 8504029, 950-0019 SS2 VENTER HOUSING KIT 8504072 REV. 0598.
Recommended Documentation:
Text Version of TJERNLUND 950-0750 SS1C FAN PROVER KIT 8504037 REV. 0994 Other Manual (Summary of Contents)
(Ocr-Read of Document's Main Page, UPD: 10 October 2023)
(950-0750) SS1C FAN PROVING SWITCH REPLACEMENT INSTRUCTIONS
WARNING: Disconnect power from SideShot
TM
and equipment by before installing Fan Proving Switch.
1. Remove wires connected to existing Fan Proving Switch terminals.
2. Remove existing Fan Proving Switch by loosening nylon nut and carefully removing sensing tube from nylon elbow.
Remove screws which attach Fan Proving Switch to electrical box.
3. Remove Bleed Orifice from bleed orifice port on existing switch and install it in new Fan Proving Switch bleed orifice port.
Otherwise use new Bleed Orifice supplied with new Fan Proving Switch.
Determine the proper Bleed Orifice to use based on the vent pipe connector length:
A. If the vent connector length is less than 3.1 equivalent meters (10 feet), then the smaller
opening #52 Bleed Orifice should be used, (See Diagram Below).
B. If the vent connector length is greater than 3.1 equivalent meters (10 feet), then the larger
opening #40 Bleed Orifice should be used, (See Diagram Below).
4. Secure proving switch to SideShot with screws.
5. Insert Fan Proving Switch sensing tube in nylon elbow connected to sensing tube port and tighten nylon nut.
6. Connect wires to terminals on new Fan Proving Switch. Blue to Common; Yellow to Normally Open.
7. Reconnect power supply. Close doors and windows and turn on all exhaust fans. Operate equipment for at least 5
minutes. Tripping of the burner circuit by the Fan Prover switch or High Limit switch during the 5 minute operation
indicates an unsafe operating condition. Turn fuel supply off to appliance and DO NOT OPERATE UNTIL UNSAFE
VENTING CONDITION IS INVESTIGATED BY QUALIFIED SERVICE PERSONNEL. For detailed safety check see
“System Check Out” in SideShot Installation Instructions. For troubleshooting see “Trouble Shooting” in SideShot
Installation Instructions or consult your Tjernlund distributor or Tjernlund’s Technical Customer Service at
1-800-255-4208; M-F 7:30 - 4:30 CST.
P/N 8504037 Copyright © 1994 Tjernlund Products, Inc. All rights reserved. REV. 9/94
TJERNLUND PRODUCTS, INC.
1601 Ninth Street • White Bear Lake, MN 55110-6794
PHONE (800) 255-4208 • (651) 426-2993 • FAX (651) 426-9547
Visit our web site • www.tjernlund.com
Recommended:
211745, HandStand PSW1-1000, carrello book, 2GBMP4-008
720 Zle Elliptical, SD990, T8.0 Treadmill, 630, WATCH KRONYS 500A, RSV4 FACTORY
-
EMC 1900M1900w Heavy Duty MicrowaveOven• 1900 watt output• Easy to use electronic dialtimer with 4 power levels• Space saving design, topmounted controls• All stainless steel with sealedin ceramic base1900 watt, heavy duty microwave oven.Two magnetrons with top and bottomfee ...
Model & Doc Type: EMC 1900M 2
-
Create your perfect sleep environment.Thank you for purchasing Sound Spa, the HoMedics acoustic relaxation machine. This, like the entire HoMedics product line, is built with high-quality craftsmanship to provide you years of dependable service.We hope that you will find it to be the finest product ...
Model & Doc Type: Soundspa 2
-
Sheet #6873, Rev. HSurge Suppression Installation ManualAquaLink® RS Installation DataIMPORTANT NOTE TO INSTALLER. This manual contains important information on maximizing the protection for your AquaLink® RS. Read the instructions carefully. Proper grounding and bonding is required ...
Model & Doc Type: AquaLink RS 8
-
EXTENSION TUBESwww.hasselblad.com1/5IMPERIAL UNITSHASSELBLAD H SYSTEMH 13mmH 26mmH 52mmPHYSICAL DATA: H 13mm H 26mm H 52mmExtension 0.51 in 1.0 in 2.1 inWeight (including covers) 4.41 oz 5.29 oz 6.88 ozExternal dimensions (including covers) 3.3 x 1.3 in 3.3 x 1.8 in 3.3 x 2.9 inEXTENSIO ...
Model & Doc Type: H SYSTEM 5
Operating Impressions, Questions and Answers:
