Stewart Audio DSP 4x4 Owner's Manual

7, 12 13 3 Operation 3.1 Operating Precautions 1. Before use, your DSP 4x4 must be congured to customize its op- eration, including input and output wiring hookup. Improper wiring can result in damage to equipment or potentially harm to the opera- tor. Consult Section 2…

12, 7 Accessories The following accessories are available from Stewart Audio for your amplier. All part numbers shown are Stewart Audio Part Numbers. To purchase these accessories or to see the full Stewart Audio product lineup, visit us at: www.stewartaudio.com Mounting B…

10, Stewart Audio DSP 4x4 18 19 5 Technical Specications Frequency Response 20Hz—20kHz ±0.2dB THD+N <0.007% Signal-to-Noise Ratio >120dB at 0dB gain Unweighted Crosstalk <-95dB Input Sensitivity -24dB to +0dB Input Impedance (Balanced/ Unbalanced/Phantom) 20k Ω, 10k Ω, 2.4k …

11, 20 21 6.2.1 Return Authorization Number All returns to the factory for service must be accompanied by a Return Authorization (RA) number. One can be obtained by contacting Stewart Audio at (209) 588-8111 or via e-mail at [email protected]. NOTE: Any defective products received wit…

6, 10 11 2.3.2 Unbalanced Input Connections When using an unbalanced input source and connector, a jumper must be added between the negative (-) terminals and the ground terminals. Once this has been done, the unbalanced source can be connected to the positive (+) and ground terminals…

3, 4 5 Table of Contents 1 Welcome Congratulations on your purchase of the new Stewart Audio DSP 4x4. This unit has been designed and built to provide you with years of high- quality audio performance and trouble-free operation. If after reading this manual you should have any …