Fanimation FP825 Owner's Manual

4, Clevis Pin Setscrew (2) 4 Electrical and Structural Requirements Ceiling Ceiling Joists 2˝ x 4˝ Outlet Box Figure 1 How to Assemble Your Ceiling Fan Pin Setscrew Hanger Ball Figure 1 1. Prior to assembly, set aside and save the hardware bag(s) packed in the packing. 2. Remove the Hanger Ball…

6, 6 How to Hang Your Ceiling Fan Figure 1 Floor No less than 7 ft ▲ WARNING The fan must be hung with at least 7´ of clearance from floor to blades (Figure 1) ▲ WARNING The outlet box must be securely anchored and capable of withstanding a load of at least 50 lbs. Hanger brac…

10, 10 Installing the LK825** ▲ WARNING To avoid fire or shock, follow all wiring instructions carefully. Any electrical work not described in these instructions should be done or approved by a licensed electrician. 1. Locate accessory mounting plate on bottom of fan. Figure 1 F…

2, Fanimation FP825 1. LIMITED LIFETIME MOTOR WARRANTY - If any part of your fan motor fails, due to a defect in materials or workmanship during the lifetime of the original purchaser, Fanimation will provide the replacement part free of charge, when the defective fan is returned to our national service center. Pr…

3, This Manual is Designed to Make it as Easy as Possible for You to Assemble, Install, Operate, and Maintain Your Ceiling Fan Unpacking Instructions For your convenience, check-off each step. As each step is completed, place a check mark. This will ensure that all steps have been completed and…

8, 8 Installing the Canopy Housing 1. Screw in two threaded rods into the Hanger Bracket (Figure 1a). NOTE: The threaded rods in the hanger bracket serve as guides for easier installation. 2. Securely attach the Canopy Housing to the Hanger Bracket using the external lockwashers and knurled knob…