Fender Power Stage 100 Owner's Manual

3, 3 Detachable Wired Remote Control Panel Variable Corner Low Pass Frequency Filter and Two Variable Center Frequency Notch Filters 1/4 inch Stereo Headphone Jack Bass/Treble Boost with Bypass Switch Phantom Power Both 1/4 inch Phone TRS and 3-Pin XLR Female Input Connectors Insert Patch Point for Si…

4, Fender Power Stage 100 4 Designed for maximum flexibility, the wired remote control section is the "brain" of the PowerStage 100. Whether hand held or mounted to a mic stand, the wired remote control unit governs all volume levels, frequency shaping and features a 1/4 inch headphone jack for personal…

5, 5 L. SUPPLY CORD JACK - The supply cord connects here. This is a grounding type supply cord to reduce the possibility of shock hazard. Be sure to connect it to a grounded receptacle. DO NOT ALTER THE AC PLUG. M.POWER SWITCH - Turns the AC power ON and OFF. When the switch is in the O…

6, 6 The PowerStage 100 utilizes a variety of connectors on its input panel. Below is a chart listing the various types of connectors on the PowerStage 100. Before using the PowerStage 100, please read and follow the steps listed below: 1. Heed all safety warnings when operating the Powe…

9, 9 FULL MIX MONITOR SET UP 1. Connect your microphone to the Mic 1 In. 2. Connect a cord from the Mic 1 Out jack to your main mixing console. This is a mic level signal. 3. Next, connect a cord from the monitor out on your mixing console back to the Aux Line In jack on the PowerStage…

12, A PRODUCT OF: FENDER MUSICAL INSTRUMENTS CORP. CORONA, CA 91720 USA SPECIFICATIONS DESIGNATION TYPE PR 306 PART NUMBER 071-0100-000 (120 V) 071-0100-030 (240 V) Aust 071-0100-040 (230 V) UK 071-0100-060 (230 V) Euro POWER SPECIFICATION 120 V version: 120 VAC, 60 Hz 360 W 230 V…