Samsung WF405ATPAWR/AA Installation Manual

Installation Manual for Samsung WF405ATPAWR/AA Laundry Appliance, Washer (1 pages)

Specifications:

249/249856-wf405atpawraa.pdf file (03 Oct 2023)
  • Manufacturer: Samsung
  • Category of Device: Laundry Appliance, Washer
  • Document: WF405ATPAWR/AA, File Type: PDF Installation Manual
  • Updated: 03-10-2023
  • Count of Pages: 1
Download WF405ATPAWR/AA Manual (1 pages)

Read PDF Document Online:

Data: UPD 3rd October 2023

Samsung WF405ATPAWR/AA Laundry Appliance, Washer PDF Installation Manual (Updated: Tuesday 3rd of October 2023 09:41:47 AM)

Rating: 4.4 (rated by 46 users)

Compatible devices: WD8704CJA, WF448AAE, DC68-01518Q, WD0854W8NF, WF407ANW/XAA, WF-R106NS, WF1124XAU, WF8700ES.

Recommended Documentation:

Text Version of Samsung WF405ATPAWR/AA Laundry Appliance, Washer Manual (Summary of Contents)

(Ocr-Read of Document's Main Page, UPD: 03 October 2023)


WASHING
MACHINE
Wrench Bolt hole covers Water supply hoses Hose guide
Tie strap 
(option)
carpenter’s
 level
PilersTape measure Flat screwdrilver
INSTALLATION GUIDE
Parts supplied Tools needed
2
REMOVING ALL SHIPPING BOLTS.
Remove all shipping bolts 
at the back of washer with 
supplied spanner.
Hold the shipping bolt 
with your hand and pull it 
through the wide section of 
the hole. Repeat for each 
shipping bolt.
Fill the holes with the 
supplied bolt hole covers.
※ CAUTION:  Failure to remove the shipping bolts will cause vibration and noise.
7
LEVEL THE WASHER BY ADJUSTING THE FOUR LEVELING LEGS.
Level the washer by turning the leveling 
wheel in or out as required by using the 
supplied wrench.
Check whether washer shakes 
and level again, if necessary.
When your washer is leveled, 
tighten the locking nuts using the 
wrench or (-) fl athead screwdriver.
※ CAUTION:  Your washer must be leveled on all four sides.  An unlevel washer may cause vibration.
1
PREPARATION.
1. Check the installation location.     
□
 CHECK : Solidly constructed fl oor (Not Carpeting and soft tile surfaces)
2. And move the washer to the installation location.
* When installing the washer on a pedestal, do the installation before next step.
□ Washer plugged in, power OK
□ No water leakage
□ Water hose connected properly
□ Drain hose connected properly
□ No vibration / noise
□ Washer leveled
□ Shipping bolts removed
       INSTALLATION 
 COMPLETION CHECKLIST

       INSTALLATION 

4
WATER HOSES INSTALLATION ON WASHER.
Connect one end of the 
COLD/HOT water supply 
hoses to the each COLD/
HOT water supply intakes 
at the back of the washer.
Tighten Coupling by hand 
until it is snug.
Then tighten two-thirds of a 
turn with pliers.
For proper operation, make 
sure both Hot & Cold hoses 
from faucets are connected to 
the corresponding Hot / Cold 
water inlets on the washer.
※ CAUTION: Make sure that the HOT & COLD hoses are switched with  each other.
COLD (Left)
Water
HOT (Right)
Water
5
French on back
Spanish on back
▶
▶
CONNECTING THE DRAIN HOSE.
To keep the drain hose 
spout bent, use the 
supplied plastic hose 
guide.
The drain hose must be 
placed at a height between 
23.6 in (60cm) and 35.4 in 
(90cm).
Laundry tub must be no 
shorter than 18 in (46 cm) 
and no longer than 96 in 
(245 cm).
Laundry tub must be no 
shorter than 18 in (46 cm) and 
no longer than 96 in (245 cm). 
Do not insert the drain hose 
too far into the stand pipe: 6 
- 8 inches, and no more.
Drain hose
Hose guide
Case 1. Wash basin Case 2. Laundry tub  Case 3. Stand pipe
Tie strap
Tie strap
Hose 
retainer
96” Max
18” Min
96” Max
18” Min
8” Max
6” Min
Hose 
retainer
6
MOVE THE WASHER TO ITS FINAL LOCATION AND MAKE SURE IT IS LEVELED.
Confi rm whether washer is well seated and does not 
shake. Adjust leveling legs, if necessary.
Your washer must be leveled on all four sides. Use a 
carpenter’s level on all four corners of your washer to 
ensure it’s level.
3
COLD & HOT WATER HOSES INSTALLATION ON FAUCETS.
Make sure a Rubber 
washer is inside each 
coupling on both ends.
Tighten Coupling by hand 
until it is snug.
Then tighten two-thirds of a 
turn with pliers.
Run water in a bowl or 
basin to get rid of any debris 
inside hose. Check for HOT 
and Cold water supply.
Rubber
washer
Coupling
Rubber washer
HOT COLD
8
Final Test : Water leakage , Vibration & Noise
1. Powering your washing machine.
2. Run a test cycle(Rinse+Spin) with small  amount of laundry such as 4~5 Towels.
(1) Check for any leakage at the hose connections. 
     ※ If water leaks while water is being supplied or drained, check the water connections. (Refer to Step 3,4,5) 
(2) Check for vibration and noise.        
     ※ If the washer rocks and vibrates excessively, level your washer again. (Refer to Step 6,7)
            Visits by a Service Engineer to explain functions, maintenance or installation is 
            not covered by warranty. 





DOC-f041599c:

Recommended:
MID7127, Master Relay, NX-3000 series, DVP-753

AQUALTIS AQ9D 49 U H, LBS65, 8316464, LAVAMAT 74610, WA70F5G4, AWM 4120
  • Printed in U.S.A.©2008 Shure Incorporated27D8643 (Rev. 9)Printed in U.S.A.SHURE MODEL UA830UHF IN-LINE RF AMPLIFIERSHURE MODÈLE UA830UHFAMPLIFICATEUR D'ANTENNE EN LIGNE RFSHURE MODELL UA830UHF IM ZEILE HF-ANTENNENVERSTÄRKERMODELO UA830 DE SHUREAMPLIFICADOR DE ANTENAS EN LINEA RFMODEL ...

    Model & Doc Type: UA830 7

  • DWG.No.TRIG.DR COMPLETEDLG Electronics Inc.UNIT SCALENSmmREVIEWEDDESIGNED주 연 수 전 종 묵 이 갑 선 김 현 석RELATED DWG.CHECKED APPROVED17.07.10 17.07.10 17.07.1017.07.10MODELINGITLETAPPROVEDPREPAREDDATEREF. NO.REV. NO.REVISION DESCRIPTION김 현 석주 연 수17/07/25EAGH700823 ...

    Model & Doc Type: WD1611SMW2 49

  • SERVICEWhirlpool EuropeCustomer Services Model AWM 4120 Version 8570 412 03000 PageTechnical data 2 - 4Spare part list 5Exploded view 6 - 7Wiring diagram 8Circuit diagram 9Program chart 10 - 14Text/Legend 15 - 16Family SC1Service ManualWashing machineFrontloaderAWM 4120AWM 4120This do ...

    Model & Doc Type: AWM 4120 16

  • 1239"(99 cm)28"(71 cm)Automatic Washer PRODUCT MODEL NUMBERSDRAIN SYSTEM OPTIONSNTW5245T NTW5400TElectrical: 120-volt, 60 Hz, AC-only, 15- or 20-amp electrical supply is required. A time-delay fuse or circuit breaker and separatecircuit are recommended.Because Whirlpool Corporation polic ...

    Model & Doc Type: NTW5245T 1

Additional Information:
# Brand Model Document Type/File Pages File Size Last Checked
1 Siemens
Washing machine
10 2.92 Mb 03/01
2 Electrolux
EWF 86110W
24 2.49 Mb 14/03
3 Haier
HWM75-1279
22 13.48 Mb 16/12
4 Whirlpool
WRSB 7259 WS EU
36 13/11
5 Indesit
IWD 71251
16 06/10
6 Haier
HWM90-L287S
18 10.01 Mb 17/12
7 Hotpoint
BHWM149
20 04/03
8 DAEWOO ELECTRONICS
Daema DWF-1801Q
17 23/10
9 Samsung
WF361
72 30/11
10 Maytag
MLE19PR
2 15/12

Popular Right Now:

# Brand Model Document (PDF) Pages Size Check Date
1 Janam
XT1
8 18.12.2023
2 Asus
P4P8X
16 0.21 Mb 24.12.2023
3 Philips
14PV210
2 26.10.2023
4 Thermal Dynamics
CUTMASTER 39
82 13.09.2023
5 Encore
ENRTR-104
1 0.67 Mb 03.10.2023
6 Neptronic
SKR-14 CASA
28 26.09.2023
7 ELRO
C904IP.2
140 30.11.2023
8 Safa Media
R200
23 02.12.2023
9 Lenovo
C2 Series
91 27.02.2024
10 ECM
Barista
34 01.02.2024
Operating Impressions, Questions and Answers: