Fiesta FG50057 Assembly Manual And Use And Care

28, 28 TANK ASSEMBLY • Position tank into tank support as shown. HOSE/REGULATOR FIG.12 Before attaching hose/regulator to tank, be sure cylinder valve and appliance valves are OFF . The Q.C.C.1 cylinder valve has an internal back check module which will not allow gas to flow unti…

25, 25 SIDE BURNER HOSE ASSEMBLY • Position hose into end of side burner venturi tube until groves line up (A). Snap clip into the groove on side burner tube to secure parts (B). • Check hose to ensure it is securely positioned in tube end. • Attach side burner Ignitor wire to terminal on s…

13, COOKING TECHNIQUES PREHEATING THE BARBEQUE The cooking system and grids require heating prior to adding food. 1.Light your barbeque as outlined in the ‘LIGHTING’ instruction section. 2.Once lit, preheat your barbeque on the HIGH setting with the lid down for 6 to 10 minutes. NOTE…

6, Fiesta FG50057 6 NOTE: IMPROPER LIGHTING PROCEDURES CAN CAUSE THE FLOW CONTROL TO ACTIVATE, RESULTING IN REDUCED HEAT OUTPUT. IF THIS IS SUSPECTED, RESET THE FLOW CONTROL BY SHUTTING OFF ALL BURNER CONTROLS AND THE CYLINDER VALVE. WAIT 30 SECONDS, THEN TURN THE CYLINDER VALVE ON EXTREMELY SLOWLY - WAIT 5 SECONDS A…

27, 27 PROVIDING POWER TO YOUR BARBEQUE IMPORTANT: To provide power to the barbecue, plug a grounded electrical cord into rear receptacle box as shown. Plug electrical cord into properly grounded GFI (Ground Fault Interrupt) receptacle. If use of an extension cord is required, be sure that it is…